c_gen_set_about_dhcp_scope

Available Languages

Updated:November 29, 2020

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

About DHCP Pools

Devices have built-in DHCP relay agents. However, to configure network segments that do not have a separate DHCP server, controllers can have built-in DHCP pools that assign IP addresses and subnet masks to clients connecting to your device. Typically, a device can have one or more DHCP pools that each provide a range of IP addresses.

DHCP pools are required for internal DHCP to work. Once DHCP is defined on the device , you can then point the primary DHCP server IP address on the management, AP-manager, and dynamic interfaces to the device’s management interface.

What to do next:

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)