The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
Configuring VLAN Interface Settings
Configuring VLAN Interface Settings
The Configure > Interface > Logical Interfaces page lists all the logical interfaces on the device.
To configure additional settings for a VLAN, select the interface from the list in the Logical Interfaces section.
In the Logical Interfaces Setup section, enter a description for the interface.
To add physical interfaces to the VLAN, click Add members. Check the check box for each interface you want to assign to the VLAN. Click Save.
To enable DHCP Relay Information, set the field to Enable.
To configure an IPv4 interface:
Assign an IPv4 address and subnet mask to the interface.
Enter the IPv4 DHCP server address.
To configure an IPv6 interface:
Assign an IPv6 address and prefix to the interface.
Enter the IPv6 DHCP server address.
To enable the interface, set the Interface Status field to On.
Enter the maximum transmission unit (MTU) for the interface. The MTU should be between 68 and 1500 bytes.