t_config_commands

Available Languages

Updated:July 31, 2020

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Commands

Commands

ClosedAbout Configuring Commands

Choose Administration > Commands to download and install new operating system software or signature files via an FTP server or a TFTP server, upload files from your device to a local TFTP or FTP server, restart your device, and set time on your device.

ClosedDownloading Files to Your Device
  1. Choose Administration > Commands.
  2. On the Commands page, click the File Download tab.
  3. From the File Type drop-down list, choose Configuration, or Webauth Bundle to specify the type of file you want to download.
  4. From the Transfer Mode drop-down list, choose TFTPor FTP to download files to your device.
  5. In the Server Details section, enter the IP address of the FTP or the TFTP server that you want to use.
  6. Specify the path from where you want to download the file, and the name of the file.
  7. Click Download File.
ClosedUploading Files from Your Device to a Server
  1. Choose Administration > Commands.
  2. On the Commands page, click the File Upload tab.
  3. From the File Type drop-down list, choose Configuration as the type of file you want to upload:
  4. From the Transfer Mode drop-down list, choose TFTPor FTP to upload files from your device.
  5. In the Server Details section, enter the IP address of the FTP or TFTP server that you want to use.
  6. Specify the path to indicate the location to which you want to upload the file, and the name of the file.
  7. Click Upload File.
ClosedReloading your Device
  1. Choose Administration > Commands.
  2. On the Commands page, click the Reload tab.
  3. You can perform the following tasks:
    • Save configuration and then reload the device.
    • Reload the device without saving your configuration.
    • Reset to factory default and then reload the device.

The Reset to Factory Default and Reload option enables you to reset device configuration to the factory default. Resetting the configuration overwrites all applied and saved configuration parameters. You are prompted for confirmation to reset the configuration. All configuration data files are deleted, and upon reboot, the device is restored to its original state. Resetting the configuration removes all IP configuration, and you will need a serial connection to restore the base configuration.

ClosedConfiguring Wireless
  1. Choose Administration > Commands.
  2. On the Commands page, click the Configure Wireless tab.
  3. Check the Configure Wireless Controller check box to enable configuration of wireless features.

 

© 2020 Cisco Systems, Inc. All rights reserved.

 

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products