The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
Configuring General System Settings
Configuring General System Settings
Enter the name of your device.
In the AP Multicast Mode field, choose either Unicast or Multicast as the packet forwarding policy that you want the device to use.
If you selected Multicast as the packet forwarding policy, enter the multicast address group to which to forward packets.
Choose the FIPS mode for the packets.
To allow clients connected to your device to move between
SSIDs, check the Fast SSID Change check box. When the client sends a new association request for a different SSID, the client
entry in the Connection table is cleared before the client is added to
the new SSID.
To enforce a delay before clients are
allowed to move to a new SSID, leave the check box unchecked.
Enter the default mobility domain name for the device.
Enter the radio frequency (RF) group name. The valid range for the RF group name is 8 to 19
characters.
Radio Resource Management (RRM) neighbor packets are distributed among access
points within an RF group. Cisco access points only accept RRM neighbor packets
sent with this RF group name. The RRM neighbor packets sent with different RF group
names are dropped.
In the User Idle Timeout field, enter the timeout in seconds for idle clients. The default is 300. When the timeout expires, the client loses authentication, briefly disassociates from the access point, reassociates, and reauthenticates the connection.
Select the AP Plug and Play check box to enable AP Plug and Play on your device. Ensure that Cisco Discovery Protocol (CDP) is enabled on the device.
Enter the ID of the AP VLAN that is not supported.
Choose the ports you want to exclude from AP plug and play.
Feedback