Device

1. Choose Administration > Device.
2. In the General section, enter a name for the device and a message in the Banner field. This message will be displayed in the banner of your device.
3. In the FTP/SFTP/TFTP section and FTP Settings area, select a source interface, enter a username and password.
4. In the SFTP Settings area, select the source interface.
5. In the TFTP Settings area, select the source interface.

6. In the Redundancy section, perform the following:

   1. To activate redundancy configuration, slide the Redundancy Configuration button to Enabled.
   2. To perform RMI+RP redundancy pairing, click RMI+RP and enter RMI IP address for chassis 1 and 2.
   3. To perform RP redundancy pairing, click RP and perform the following:
      • Enter an IP address for Local IP.
      • Enter the subnet mask assigned to all wireless clients.
      • From the HA Interface drop-down list, choose one of the HA interface.
      • Enter an IP address for Remote IP.
7. Enter an appropriate timer value in Keep Alive Timer. The valid range is between 1 and 10 (x100 milliseconds).
8. Enter an appropriate retry value in Keep Alive Retries. The valid range is between 3 and 10 seconds.
9. Enter a value for Active Chassis Priority.
10. Click Apply.

Note: To disable redundancy configuration, slide the Redundancy Configuration button to Disabled.

 

© 2020 Cisco Systems, Inc. All rights reserved.