r_mon_gen_redundancy

Available Languages

Updated:January 20, 2020

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Monitoring Redundancy

Monitoring Redundancy

Choose Monitoring > General > Redundancy to view information in the following sections:

ClosedStates
Parameter Description

My State

The state of the active CPU controller module.

Values are as follows:

  • Active
  • Standby
  • HOT Disable
Peer State

The state of the peer (or standby) CPU controller module. Values are as follows:

  • Standby
  • HOT Disable
Mode

The current state of the redundancy peer. Values are as follows:

  • Simplex— Single CPU controller module
  • Duplex— Two CPU controller modules
Unit ID The unit ID of the CPU controller module.
Redundant Mode (Operational) The current operational redundancy mode supported on the unit.
Redundancy Mode (Configured) The current configured redundancy mode supported on the unit.
Redundancy State

The current functioning redundancy state of the unit. Values are as follows:

  • SSP
  • Not Redundant
Manual Swact Displays whether manual switchovers have been enabled without the force option.
Communications Displays whether communications are up or down between the two CPU Switch modules.
Client Count The number of redundancy subsystems that are registered as RF clients.
Client Notification TMR The time, in milliseconds, that an internal RF timer has for notifying RF client subsystems.
RF Debug Mask Internal mask used by the RF to keep track of which debug modes are on.
ClosedSwitch Over History
Parameters Description
Index The index number of the of the redundant unit.
Previous Active The device that was active before.
Current Active The device that is currently active
Switch Over Time The system time when the switchover occurs.
Switch Over Reason The reason for the switchover.

 

© 2020 Cisco Systems, Inc. All rights reserved.

 

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products