t_admin_roll_ap_upgrade

Available Languages

Updated:January 22, 2019

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Rolling AP Upgrade

Configuring Rolling AP Upgrade

Creating an SMU with AP Images

On the Administration > Rolling AP Upgrade page, click Add. The Add a SMU with AP images window is displayed.

  1. From the Transport Type drop-down list, choose the transport type as TFTP, FTP, Device, or Desktop (HTTPS).
  2. If you choose TFTP as the transport type, you need to enter the source IP address, file path, and select a file system.
  3. If you choose FTP as the transport type, you need to enter the source IP address, FTP username, FTP password, file path, and select a file system.
  4. If you choose Device as the transport type, choose the file system and file path.
  5. If you choose Desktop (HTTPS) as the transport type, choose the file system. From the Source File Path field, click Select File to navigate to the file.
  6. Click + Add File.

Note: Click Activate to activate the file (or) Commit to commit the file.

Configuring Rolling AP Upgrade

On the Administration > Rolling AP Upgrade page and AP Upgrade Configuration section, perform the following:

  1. From the AP Upgrade per Iteration drop-down list, choose the iteration as 5%, 15%, or 25%.
  2. Click Apply.

 

© 2018 Cisco Systems, Inc. All rights reserved.

 

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products