The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
The Cisco Aironet 700 Series is a compact access point that delivers secure and reliable wireless connections. The main features are:
Simultaneous dual band, dual radio with support for 2.4GHz and 5GHz.
Optimized antenna and radio designs: Consistent network transmit and receive for optimized rate versus range.
Radio resource management (RRM): Automated self-healing optimizes the unpredictability of RF to reduce dead spots and help ensure high-availability client connections.
Cisco BandSelect improves 5-GHz client connections in mixed-client environments.
Advanced security features including Rogue Detection, wIPS and Context-Aware.
The Cisco 700 series access points has four LAN ports. The configuration of these ports is stored in a file on flash. The AP retrieves the configuration when restarted. The AP then shares the information with Controller after joining so that Controller can display the updated information.
![]() Note | The AP deletes the saved port information and applies the default configuration when the controller clears all the existing configuration on the AP. All LAN ports are disabled by default. |
Enable or disable a LAN port on the access point by entering this command: config ap lan port-id port-id {enable | disable} AP-NAME
See the port information by entering this command: showap lan port-id port-id AP-NAME
See the port summary information by entering this command: showap lan port-summary AP-NAME
In Release 7.6, there is no support for administrating the Ethernet ports or assigning them to different VLANs. All ports are mapped to the same access VLAN that AP's switch port is configured to. Alternatively, the ports are mapped to the native VLAN if port is a trunk. In 8.0 and later releases, it is possible to enable or disable the ports and map them to specific VLANs if needed. This allows traffic to be separated not only between wireless and wired networks, but also among the four Ethernet ports.