When you create two or more AP-manager interfaces, each one is mapped to a different port. The ports should be configured in sequential order so that AP-manager interface 2 is on port 2, AP-manager interface 3 is on port 3, and AP-manager interface 4 is on port 4.
Before an access point joins a controller, it sends out a discovery request. From the discovery response that it receives, the access point can tell the number of AP-manager interfaces on the controller and the number of access points on each AP-manager interface. The access point generally joins the AP-manager with the least number of access points. In this way, the access point load is dynamically distributed across the multiple AP-manager interfaces.
Access points may not be distributed completely evenly across all of the AP-manager interfaces, but a certain level of load balancing occurs.
Configuring Multiple AP Manager Interfaces
restrictions apply while configuring the multiple AP manager interfaces in the
You must assign
an AP-manager interface to each port on the controller.
implementing multiple AP-manager interfaces, you should consider how they would
impact your controller’s port redundancy.
AP-manager interfaces do not need to be on the same VLAN or IP
subnet, and they may or may not be on the same VLAN or IP subnet as the
management interface. However, we recommend that you configure all AP-manager
interfaces on the same VLAN or IP subnet.
If the port of one of the
AP-manager interfaces fails, the controller clears the state of the access
points, and the access points must reboot to reestablish communication with the
controller using the normal controller join process. The controller no longer
includes the failed AP-manager interface in the CAPWAP or LWAPP discovery
responses. The access points then rejoin the controller and are load balanced
among the available AP-manager interfaces.
In the case of
management interface, because there is support for backup port, APs already
connected to management interface continue to be in connected state (falling to
backup port) rather than dropping off. However, AP-Mgr will get disabled any
new APs will associate with the current AP-Mgr.
Creating Multiple AP-Manager Interfaces (GUI)
Choose Controller > Interfaces to open the Interfaces page.
The Interfaces > New page appears.
Enter an AP-manager interface name and a VLAN identifier.
Click Apply to commit your changes. The Interfaces > Edit page appears.
Enter the appropriate interface parameters.
Every interface supports primary and backup port with the following exceptions
Dynamic interface is converted to AP manager which does not support backup of port configuration.
If AP manager is enabled on management interface and when management interface moves to backup port because of primary port failure, the AP manager will be disabled.
To make this interface an AP-manager interface, select the Enable Dynamic AP Management check box.
Only one AP-manager interface is allowed per physical port. A dynamic interface that is marked as an AP-manager interface cannot be used as a WLAN interface.
Click Save Configuration to save your settings.
Repeat this procedure for each additional AP-manager interface that you want to create.