Service name
|
The name of the GGSN
service.
|
Context
|
The context name where
the GGSN service is configured.
|
Associated PGW svc
|
The name of the P-GW
service associated to the GGSN service.
|
Associated GTPU svc
|
The name of the GTP-U
service associated to the GGSN service.
|
Associated IPNE svc
|
The name of the IPNE
service associated to the GGSN service.
|
Associated Peer map
|
The name of the peer
map associated to the GGSN service.
|
Accounting Context
Name
|
The context name where
the accounting configuration and/or interface(s) are configured.
|
dns-client Context
Name
|
The context name in
which a DNS client configuration is present.
|
Authorize
|
Enables/disables
subscriber session authorization with HSS over S6b Diameter interface.
|
S6b IPv6 Reporting
|
Specifies if the IPv6
address reporting through AAR towards the S6b interface is enabled
or disabled.
|
Fqdn-name
|
The name of Fully
Qualified Domain Name (FQDN) which is used for authorization over
S6b interface between GGSN and 3GPP AAA/HSS.
|
Bind
|
Binds the GGSN service
to a logical IP interface serving as the Gn interface.
|
Local IP Address
|
The IP address (IPv4
and/or IPv6)) of the interface configured as the Gn interface.
|
Self PLMN Id
|
Specifies the GGSN's
public land mobile network (PLMN) identifiers.
|
Retransmission Timeout
|
The time to control
the retransmission of GTP control packets when no response is received
from an SGSN.
|
Max Retransmissions
|
Indicates the maximum
number of times that GTP control packets are retransmitted.
|
Restart Counter
|
Specifies the restart
counter
|
Echo Interval
|
Specifies the frequency
at which the GGSN service sends GTPv1-C Echo packets to the SGSN(s)
it is configured to communicate with.
|
GTPC Echo Mode
|
Specifies if GTP-C
echo mode is set as default.
|
GTPC Echo Retransmission Timeout
|
Specifies the frequency
at which the GGSN service retransmits GTPv1-C Echo packets to the
SGSN(s) it is configured to communicate with.
|
Guard Interval
|
Specifies the amount
of time that must pass before a GGSN service treats a redundant
PDP context request as a new request instead of a re-send of a previous
request.
|
Setup Timeout
|
Specifies the maximum
amount of time the GGSN service allows for the setting up of PDP
contexts.
|
PLMN Policy
|
Specifies the public
land mobile network (PLMN) policy.
|
Unlisted SGSN PLMN Id.
|
Specifies the PLMN ID
of the unlisted SGSN.
|
SGSN MCC MNC preference
|
Specifies the MCC and
MNC preference for SGSN.
|
Unlisted SGSN rat-type
|
Specifies the type of
the radio acess technology for unlisted SGSN.
|
Reject Code Policy
|
Authentication Server
Timeout
|
Specifies the reject
code used by the GGSN if communication with an authentication server
times out.
|
Accounting Server
Timeout
|
Specifies the reject
code used by the GGSN if communication with an accounting server
times out.
|
Ran Procedure Ready
|
Specifies if the RAN
Procedure Ready feature is enabled/disabled for the specified
GGSN service.
|
NSAPI in Create PDP
response
|
Specifies the Network
Service Access Point Identifier in the Create PDP response.
|
Map MBR to AMBR in
Update PDP request
|
Indicates the status
of MBR to AMBR mapping in Update PDP Context Request message.
|
Suppress NRUPC triggered
by CPC
|
Indicates if suppress
NRUPC triggered by CPC is enabled or disabled.
|
Suppress NRUPC triggered
by UPC
|
Indicates if suppress
NRUPC triggered by UPC is enabled or disabled.
|
Support e-ARP
|
Indicates if the support
for enhanced ARP is enabled or disabled.
|
Decode MCC MNC parameter
of ULI as HexaDecimal Digits
|
Indicates if the decoding
of MCC and MNC parameters of ULI as hexadecimal digits has been
enabled or disabled.
|
Duplicate Subscriber
Address Request
|
Specifies the status
of duplicate subscriber address request.
|
trace-collection-entity
|
Specifies the trace
collection entity which is the destination node in Network management
where trace files are transferred to and stored.
|
Path Failure Detection
on gtp msgs
|
Specifies the path
failure detection policy on GTP-U echo messages that have been retransmitted
the maximum number of retry times.
|
GTP Private Extensions
|
Specifies the customer
specific private extension in GTP-C messages.
|
Max IP sessions
|
Specifies the maximum
numner of IP sessions.
|
Max PPP sessions
|
Specifies the maximum
number of PPP sessions in GGSN service.
|
Max sessions
|
Specifies the total
number of maximum sessions including IP and PPP in GGSN service.
|
Max Primary sessions
|
Specifies the total
number of maximum primary sessions including IP and PPP in GGSN
service.
|
Max Sec-per-primary
sessions
|
Specifies the total
number of maximum secondary sessions per primary session in GGSN
service.
|
Service Status
|
Specifies the status
of the GGSN service.
|
Newcall Policy
|
Specifies if the new
call related behavior of GGSN service is enabled/disabled
when duplicate sessions with same IP address request is received.
|
MBMS Policy
|
Specifies the configured
MBMS policy for Multicast and/or Broadcast mode in this
GGSN service.
|
MBMS Charging ID Optimization
|
Specifies if the MBMS
charging ID optimization is enabled/disabled for the GGSN
service.
|
GTPC Prioritized APN(s
|
Specifies if the prioritized
APNs have been added for prioritized handling of VoLTE/Emergency
calls even under congestion for the GGSN service.
|
GTPC Prioritized ARP(s)
|
Specifies if the prioritized
ARPs have been added for prioritized handling of VoLTE/Emergency
calls even under congestion for the GGSN service.
|
GTPC Prioritized Rel99
ARP(s)
|
Specifies if the prioritized
Release 99 ARPs have been configured for prioritized handling of
VoLTE/Emergency calls even under congestion for the GGSN
service.
|
3GPP Qos to DSCP Mapping
(for G-PDUs)
|
This group indicates
the 3GPP QoS to DSCP mapping information.
|
qci 1: ef
|
Indicates the DSCP
configured for QCI1 type of traffic.
|
qci 2: ef
|
Indicates the DSCP
configured for QCI2 type of traffic.
|
qci 3: af11
|
Indicates the DSCP
configured for QCI3 type of traffic.
|
qci 4: af11
|
Indicates the DSCP
configured for QCI4 type of traffic.
|
qci 5: ef
|
Indicates the DSCP
configured for QCI5 type of traffic.
|
qci 6: ef
|
Indicates the DSCP
configured for QCI6 type of traffic.
|
qci 7: af21
|
Indicates the DSCP
configured for QCI7 type of traffic.
|
qci 8: af21
|
Indicates the DSCP
configured for QCI8 type of traffic.
|
qci 9: be
|
Indicates the DSCP
configured for QCI9 type of traffic.
|
3GPP Qos to DSCP Mapping
based on Alloc. Prio
|
This group indicates
the 3GPP QoS to DSCP mapping information based on allocation priority.
|
qci 5 ( Alloc.P 1):
ef
|
Indicates the DSCP
configured for QCI5 type of traffic with allocation priority 1.
|
qci 5 ( Alloc.P 2):
ef
|
Indicates the DSCP
configured for QCI5 type of traffic with allocation priority 2.
|
qci 5 ( Alloc.P 3):
ef
|
Indicates the DSCP
configured for QCI5 type of traffic with allocation priority 3.
|
qci 6 ( Alloc.P 1):
ef
|
Indicates the DSCP
configured for QCI6 type of traffic with allocation priority 1.
|
qci 6 ( Alloc.P 2):
ef
|
Indicates the DSCP
configured for QCI6 type of traffic with allocation priority 2.
|
qci 6 ( Alloc.P 3):
ef
|
Indicates the DSCP
configured for QCI6 type of traffic with and allocation priority
3.
|
qci 7 ( Alloc.P 1):
af21
|
Indicates the DSCP
configured for QCI7 type of traffic with allocation priority 1.
|
qci 7 ( Alloc.P 2):
af21
|
Indicates the DSCP
configured for QCI7 type of traffic with allocation priority 2.
|
qci 7 ( Alloc.P 3):
af21
|
Indicates the DSCP
configured for QCI7 type of traffic with allocation priority 3.
|
qci 8 ( Alloc.P 1):
af21
|
Indicates the DSCP
configured for QCI8 type of traffic with allocation priority 1.
|
qci 8 ( Alloc.P 2):
af21
|
Indicates the DSCP
configured for QCI8 type of traffic with allocation priority 2.
|
qci 8 ( Alloc.P 3):
af21
|
Indicates the DSCP
configured for QCI8 type of traffic with allocation priority 3.
|
GTPC messages
|
Indicates the Best
effort forwarding PHB for GTPC messages.
|
CC Behavior
|
Specifies the 3GPP
behavior bit associated with the GGSN's charging characteristics.
|
Charging Characteristics
(CC) Profiles
|
This group provides
the charging characteristics profiles configured in this GGSN service.
|
Bucket
|
Specifies the charging
bucket configured for charging characteristic in this GGSN service
|
SGSN Configuration
List
|
Specifies the list
of SGSNs that this GGSN service is allowed to communicate with.
|
GTPC Outgoing Throttling
|
Specifies if outgoing throttling has been
enabled, which indicates the number of messages that were removed
from the queue (due to any collision, or max retransmission expired).
|
RLF Template Name
|
Specifies the template name for RLF for
throttling support.
|
GTPC Incoming Throttling Params
|
Specifies if the incoming throttling of
GTPC has been configured. It includes following parameters:
|
Message Rate (per sec)
|
Indicates the number of messages per second.
Default: 20000
|
Delay Tolerance (secs)
|
Indicates the delay tolerance in seconds.
Default: 5
|
Queue Size
|
Indicates the queue size. Default: 10000
|