security association rekeying.
HNBGW is not supported from Release 20 and later, and HeNBGW is not supported in Releases 20, 21.0 and 21.1. This command
must not be used for HNBGW and HeNBGW in these releases. For more information, contact your Cisco account representative.
Exec > Global
Configuration > Context Configuration > Crypto Map IKEv2-IPv6
Configuration > Crypto Map IKEv2-IPv6 Payload Configuration
configure > context
> crypto map
ikev2-ipv6 > payload
Entering the above
command sequence results in the following prompt:
rekey [ keepalive ]
[ default | no ] rekey
Returns the feature
to the default setting of disabled.
If specified, a
session will be rekeyed even if there has been no data exchanged since the last
rekeying operation. By default rekeying is only performed if there has been
data exchanged since the previous rekey.
Use this command to
enable or disable the ability to rekey IPSec Child SAs after approximately 90%
of the Child SA lifetime has expired. The default, and recommended setting, is
not to perform rekeying. No rekeying means the P-GW will not originate rekeying
operations and will not process CHILD SA rekeying requests from the MS.
command disables rekeying: