This procedure boots
the system using the specified boot image without also loading a configuration
file. A sample command string appears below:
8/0:cli>boot -noconfig /flash/image_filename.bin
The boot sequence
ends with a prompt to enter the Quick Setup Wizard for creating a configuration
Starting program at 0x0000000000100000
Starent Networks ASR5500 Intelligent Mobile Gateway
management_card is starting up..............................
Starting software image_version_number...
No configuration found, press enter to continue.
1. Do you wish to continue with the Quick Setup Wizard[yes/no]:
You can exit the
Quick Setup Wizard by entering
no in response
to the above prompt. Load a desired configuration file using the Exec mode
command followed by the URL for the configuration file as shown in the example
[local]host_name# configure /flash/system.cfg