The SYSLINUX bootloader allows you to specify the priority of the boot image from which you would like to boot the system. If a VPC VM failed to reload following a software update, you can initiate a boot from a previously stored image.
The system recovery process will prompt you to enter the path name for the location of the StarOS boot image from which the system will boot. By default the boot command will timeout and attempt to reload the highest priority image from flash memory using the default configuration file.
The StarOS software is delivered as a single binary file (.bin file extension) and is loaded as a single instance for the entire system.
- For StarOS releases prior to 16.1, the image filename is identified by its release version and corresponding build number. Format = production.build_number.platform.bin.
- For StarOS release 16.1 onwards, the image filename is identified by its platform type and release number. Format = platform-release_number.bin.
Multiple boot priorities are provided, each of which consist of a boot image (.bin) and configuration file. The lowest boot priority will be automatically booted on each boot. However, on startup a different priority can be manually booted by entering its number at the SYSLINUX "boot:" prompt.
VPC VMs do not support booting from the network; they can only be booted from the local vHDD.
Refer to the Configuring the Boot
Stack section in the Software
Management Operations chapter for additional information on
boot stack entries and prioritization.