System Management Card CompactFlash Memory Thresholds
Card CompactFlash Memory Thresholds
card CompactFlash memory utilization thresholds generate alerts
or alarms based on the percentage of memory used for the CompactFlash
during the polling interval. A single threshold enables memory utilization
monitoring for both the active and standby system management cards
allowing for alerts or alarms to be generated for each CompactFlash.
Alerts or alarms are
triggered for CompactFlash memory utilization based on the following
Enter condition: Actual
percentage memory utilization > or = High Threshold
Clear condition: Actual
percentage memory utilization < Low Threshold
If a trigger condition
occurs within the polling interval, the alert or alarm will not
be generated until the end of the polling interval.
Saving Your Configuration
When you configure
thresholds they are not permanent unless you save the changes. When you
have completed configuring thresholds, save your configuration to
flash memory, an external memory device, and/or a network
location using the Exec mode command save configuration.
For additional information on how to verify and save configuration
files, refer to the System Administration Guide and the Command
Line Interface Reference.