alerts or alarms based on either the total number of ePDG calls
setup by the system during the specified polling interval, or on
the number of currently active calls only.
Alerts or alarms are
triggered for call setups based on the following rules:
Enter condition: Actual
number of call setups > or = High Threshold
Clear condition: Actual
number of call setups < Low Threshold
If a trigger condition
occurs within the polling interval, the alert or alarm will not
be generated until the end of the polling interval.
Default ePDG threshold
polling interval value is 5 Min.
The polling interval
is in seconds and it is an integer between 30 and 60000. Entries
will be rounded up to the nearest 30 seconds.
Use the following configuration
example to enable, disable and configure ePDG threshold monitoring.
configure [ no ] threshold monitoring epdg-servicethreshold epdg-current-sessionscurrent_epdg_sessions_thresholdclearalarm_clear_thresholddefaultthreshold epdg-current-sessionsthresholdpollepdg-current-sessionsintervalthreshold_polling_intervaldefaultthresholdpollepdg-current-sessionsinterval end
Saving Your Configuration
When you configure
thresholds they are not permanent unless you save the changes. When you
have completed configuring thresholds, save your configuration to
flash memory, an external memory device, and/or a network
location using the Exec mode command save configuration.
For additional information on how to verify and save configuration
files, refer to the System
Administration Guide and the Command Line Interface
tunnel setup attempts
Use the following configuration example to enable, disable and
configure ePDG threshold monitoring.