Thresholds generate alerts or alarms based on either the total number
of Content Filtering calls setup by the system during the specified polling
interval, or on the number of currently active calls only.
Alerts or alarms are triggered for call setups based on the following
Enter condition: Actual number of call setups > or =
Clear condition: Actual number of call setups < Low
If a trigger condition occurs within the polling interval, the alert
or alarm will not be generated until the end of the polling interval.
Default value is 0, which means there will be no monitoring.
The polling interval is in seconds and it is an integer between 30 and
60000. Entries will be rounded up to the nearest 30 seconds.
describes how to enable and configure Content Filtering thresholds.
When you configure
thresholds they are not permanent unless you save the changes. When you
have completed configuring thresholds, save your configuration to
flash memory, an external memory device, and/or a network
location using the Exec mode command save configuration.
For additional information on how to verify and save configuration
files, refer to the System Administration Guide and the Command
Line Interface Reference.