Table 1 show bearer-control-profile full name Command Output
Bearer Control Profile Name
Indicates the Bearer Control Profile
Defines (MME) mapping of EPC QOS (non-standard QCIs) to 3GPP
PreRelease8 QoS parameters.
Indicates the UMTS traffic classified into the following:
traffic handing priority
Traffic handling priority specifies the relative importance
of handling all SDUs that belong to the UMTS bearer compared to the SDUs of
other bearers. The priority value ranges from 1 to 3, where the value 1 holds
the highest priority. The predefined thp value is 3.
sdu error ratio
Service Data Unit (SDU) Error ratio indicates the fraction of
SDUs lost or detected as error packets. SDU error ratio is defined only for
conforming traffic. The range is an integer ranging from 1 to 7. The ratio
ranges from 10^-1 to 10^-6. Allowed values are 1(10^-2), 2(7*10^-3), 3(10^-3),
4(10^-4), 5(10^-5), 6(10^-6) and 7(10^-1). The predefined minimum value is 1.
minimum transfer delay
Defines the maximum delay for 95 percentile of the delay
distributed for all delivered SDUs during the lifetime of a bearer service. The
delay value ranges from 10 to 40,000 milliseconds. The predefined minimum value
The delay for an SDU is defined as the time from request to
transfer and SDU at one SAP to its delivery at the other SAP.
source stats descriptor
Toggles the source statistics descriptor. The values are
either 0 or 1.