The QoS profile received from PCRF is given priority as compared to the QoS profile received from the P-GW.

AMBRs received from PCRF are given priority when there is bandwidth limitation.

If the Rule Level AMBRs are present, then first, the rule level bandwidth limiting is enforced and then, the APN level AMBR is enforced only for the non-GBR QCI values.

In the accounting start message, if the QoS profile is received with GBR QCI, then the call is dropped on the IPSG. It is assumed that the QoS profile that is being received on IPSG is of default-bearer on the P-GW.

If IPSG receives an interim update for a subscriber with a GBR QCI value, then the QCI profile is ignored and no CCR-U is sent to the PCRF.

If the CLI command radius accounting interim create-new-call is configured under the IPSG service and a QoS profile is received with GBR QCI as part of the interim RADIUS update message, then the call is dropped on the IPSG. It is assumed that the QoS profile that is being received on IPSG is of the default bearer on the P-GW.

To see the QoS profile and QCI information in the CCR-U, you must enable the trigger for the QoS change and default bearer QoS change.

Support for the EUTRAN RAT type on IPSG creates an EPS bearer.

The ULI information includes TAI+ECGI, TAI, and ECGI.

This ULI information is populated to the eGCDRs and the CDRs.

The EPS QoS information received as part of the RADIUS message is also parsed.

The bearer type (EPS), RAT Type (eUTRAN, ULI (TAI + ECGI + TAI), and EPS QoS Information that is received as part of RADIUS message is conveyed to the Gx.

When an interim update is received from the P-GW, IPSG handles this interim update. If the PCRF is registered as ULI change or QoS change, CCR-U is sent to the PCRF with the received information.

Handoff scenarios are not supported.

Gy interface is not supported.

CoA and disconnect messages handling is not supported.