ACS IMSI Pool Configuration
Mode Commands
The ACS IMSI Pool Configuration
Mode is used to define a pool of subscriber International Mobile
Station Identifier (IMSI) numbers within the ACS Configuration Mode.
IMSI pool configuration facilitates creation of rules to handle
the packets coming from or going to a group of subscriber of IMSI numbers
within an access policy.
Mode
Exec > ACS Configuration
> ACS IMSI Pool Configuration
active-charging service service_name > imsi-pool imsi_pool_name
Entering the above
command sequence results in the following prompt:
[local]host_name(config-acs-imsi-pool)#
Important: The commands or keywords/variables
that are available are dependent on platform type, product version,
and installed license(s).
end
Exits the current
configuration mode and returns to the Exec mode.
Privilege
Security Administrator,
Administrator
Syntax
Syntax Description
end
Usage Guidelines
Use this command to
return to the Exec mode.
exit
Exits the current
mode and returns to the parent configuration mode.
Privilege
Security Administrator,
Administrator
Syntax
Syntax Description
exit
Usage Guidelines
Use this command to
return to the parent configuration mode.
imsi
This command allows
you to add/remove an individual or a range of subscriber IMSI
numbers from the current IMSI pool.
Privilege
Security Administrator,
Administrator
Mode
Exec > ACS Configuration
> ACS IMSI Pool Configuration
active-charging service service_name > imsi-pool imsi_pool_name
Entering the above
command sequence results in the following prompt:
[local]host_name(config-acs-imsi-pool)#
Syntax
Syntax Description
[ no ] imsi { imsi_number | range start_imsi to end_imsi }
no
If added previously,
removes the specified subscriber IMSI number(s) from the current
IMSI pool.
imsi_number
Specifies an IMSI number
to add to the current IMSI pool.
imsi_number must
be an IMSI number, and must be a sequence of hexadecimal digits
between 1 and 15.
start_imsi to end_imsi
Specifies a range of
IMSI numbers to add to the current IMSI pool.
start_imsi specifies
the starting IMSI number of the range and must be less than end_imsi.
end_imsi specifies
the ending IMSI number of the range and must be greater than start_imsi.
Usage Guidelines
Use this command to
add an individual or range of subscriber IMSI numbers to an IMSI pool.
Up to 10 sets of IMSI numbers can be configured in each IMSI pool.
Example
The following command
adds IMSI numbers from 310150987654321 to 310150987656879 to
the current IMSI pool:imsi range 310150987654321 to 310150987656879