associate
Associates or disassociates supportive services and templates with the MME-eMBMS service.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > MME-eMBMS Service
configure > context context_name > mme-embms-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mme-embms-service)#
Syntax
[ no ] associate { egtp-service service_name [ context ctxt_name ] | sctp-param-template template_name
no
Disassociates a previously associated service or template from this MME-eMBMS service configuration.
egtp-service service_name
Specifies the name for a pre-configured eGTP service to associate with the MME-eMBMS service. The eGTP service provides eGTP-C protocol interface support between EPS nodes. Only one eGTP service can be associated with an MME-eMBMS service.
The eGTP service should be configured prior to issuing this command. For more information about the eGTP service, refer to the egtp-service command in the Context Configuration Mode Commands chapter and the eGTP Service Configuration Mode Commands chapter.
service_name is an alphanumeric string of 1 through 63 characters.
Important |
Service names must be unique across all contexts within a chassis. |
context ctxt_name
Identifies a specific context name where the named eGTP service is configured. If this keyword is omitted, the eGTP service must exist in the same context as the MME-eMBMS service.
ctxt_name is an alphanumeric, case-sensitive string of 1 through 63 characters.
sctp-param-template template_name
Associates a Stream Control Transmission Protocol (SCTP) parameter template with this MME-eMBMS service. For more information on the SCTP parameter template, refer to the sctp-param-template command in the Global Configuration Mode Commands chapter and the SCTP Parameter Template Configuration Mode Commands chapter.
template_name specifies the name for a pre-configured SCTP parameter template to associate with this MME-eMBMS service. The name entered must be an alphanumeric string of 1 through 63 characters.
Usage Guidelines
Use this command to associate a pre-configured eGTP service or SCTP parameter template with the MME-eMBMS service.
Examples
no associate egtp-service egtp1