In the Unified CVP Operations Console, navigate to Device Management > Gateway.

Click Add New.

On the General tab, configure as follows:

1. Enter the IP address.

2. Enter the hostname.

3. Choose the Device Type.

4. In the Username and Passwords pane, enter the username, password, and enable password.

Click Test Sign-in to verify that a connection with the gateway can be established and that the credentials are correct.

Click Save.

Repeat for every gateway.

Log in to the Operations Console and select Bulk Administration > File Transfer > Scripts and Media.

In the Select device type field, select the Gateway.

Move all Gateways to Selected.

Select Default Gateway files.

Select Transfer, and then select OK on the popup window.

Click File Transfer Status to monitor transfer progress.

In the Unified CVP Operations Console, navigate to SNMP > V1/V2c > Community String .

Click Add New.

1. On the General tab, name the community string.

2. On the Devices tab, select the required device from the list of available devices.

3. Click Save and Deploy.

Create the notification destination and deploy to all of the Unified CVP devices.

1. Navigate to SNMP > V1/V2c > Notification Destination.

2. Click Add New.

3. Complete the fields.

4. Select the Devices tab and assign the SNMP notification destination to a device.

5. Click Save and Deploy.

In the Unified CVP Operations Console, navigate to System > SIP Server Group.

Create a server group for the Cisco Unified Communications Manager devices:

1. On the General tab, click Add New.

2. Fill in the SRV Domain Name FQDN field with a value that will also be used in the Cluster FQDN setting in Enterprise Parameters in Communications Manager. For example, cucm.cisco.com.

3. In the IP Address/Hostname field, enter an IP address or hostname for a Unified Communications Manager subscriber.

4. Click Add.

5. Repeat Steps c and d for each Unified Communications Manager subscriber. Click Save.

   Note	Do not put the Publisher node in the server group.

   SIP server group for Communications Manager is not required for Small Contact Center (SCC) deployment as there is no direct SIP trunk created from Communications Manager to CVP in SCC model.

Create a server group for the gateway devices:

1. On the General tab, click Add New.

2. In the SRV Domain Name FQDN field, enter the SRV Domain Name FQDN. For example vxmlgw.cisco.com.

3. In the IP Address/Hostname field, enter an IP address or hostname for a VXML gateway in the deployment.

4. Click Add.

5. Repeat Steps c and d for each VXML gateway as appropriate for the deployment and branches. Click Save.

   Adding all VXML gateways to the server group will load balance calls across all the member server group gateways.

Associate these server groups to all Unified CVP Call Servers:

1. On the Call Server Deployment tab, move all Unified CVP Call Servers from the Available list to the Selected list.

2. Click Save and Deploy.

In the Unified CVP Operations Console, navigate to System > Dialed Number Pattern.

For each dialed number pattern in the following table:

1. Click Add New.

2. In the Dialed Number Pattern field, enter the dialed number pattern.

3. In the Description field, enter a description for the dialed number pattern.

4. In the Dialed Number Pattern Types pane, check the specified dialed number pattern types.

5. Click Save.

After you configure all dialed number patterns, click Deploy.

Click Deployment Status to make sure that you applied the configuration.