After you install
the Controller, you must sign in to the Administration Console to perform tasks
as explained in this chapter.
The tasks below
are not applicable for a Live Data and IdS deployment.
To sign in, open a
browser and enter the URL for your Controller (http://<HostAddress>/oamp), where HostAddress is
the host name or IP Address of the
Controller. This opens the Administration Console.
Sign in using the
System Application credentials.
||Sign in to the
Administration Console and select
license file (Browse) and navigate to the local directory where
your license is stored. Then click
License to load the license.
Define Member Node in Administration Console
If you intend to add a Member node, you must define the Member in the
Administration console before you run the installation for the Member.
||To access the Administration console, direct a browser to the URL
where HOST ADDRESS is the IP Address or Hostname of your
||Sign in using the system application user ID and password that you
defined during installation. Refer to your
||From the panel in the left, select the
Device Management drawer. Then select
Figure 1. Device Configuration|
The Device Configuration page shows the Controller that you have
installed. Note that the hostname defaults to the alias CUIC1. (You can change
||On the Device Configuration page, click
||On the Device Configuration fields for the new Member, enter a
name by which you can identify the Member, the hostname or IP address, and a
description for the device.
The Member appears on the Device Configuration list.
Figure 2. Member Configured
Verify Controller Is
Synchronized with NTP Server
Make sure that the Network
Time Protocol (NTP) on the Controller node is synchronized with the NTP server
before you install the Member node.
To do this:
Command Line Interface on the Controller node directly, by using the monitor
and keyboard at the server console. At the login prompt:
- Enter the ID
for the System Administrator user (created during Basic Install configuration).
prompted, enter the password for the System Administration user.
must indicate that the node is synchronized with an NTP server. If the
Controller node is not synchronized with an NTP server, the installation of the
Member node will fail.
Now that the Member is defined in Device Configuration and the NTP synchronization is verified, you can begin to configure and install that member. For more information, see Installation and Configuration for Member Node.