When you complete
the basic install configuration and select
Yes to indicate that you are installing the first
node, perform the following steps to complete the configuration for the
The first screen you
see is the
Time Protocol Client Configuration
This screen gives
the option of setting the time for the first node (the Controller) from a time
that you set on the Hardware Clock screen - or - from an external Network Time
Protocol server that you define.
NTP server configuration is
mandatory for Unified Intelligence Center installation over a Virtual
Network Time Protocol
configuration is set for the first node. Other nodes set their time to the time
on the first node.
Yes at the
Time Protocol Client Configuration screen.
Network Time Protocol Client Configuration screen
Enter the IP
address, NTP server name, or NTP Server Pool name for at least one external NTP
You can add up
to five NTP servers and make changes to the NTP server list at a later time.
You should use a minimum of
three external NTP servers.
complete the NTP configuration, select
Configuration screen opens.
Database Access Security password. This is the password that servers in the
cluster use to communicate with each another.
must enter the same security password for all servers.
OK to open the SMTP Host Configuration screen.
Host Configuration screen, select whether you want to configure an
SMTP host to receive platform-level emails, for example, emails about
certificate expiration. This field is optional. You will configure email for
report scheduling in the Administration console.
want to configure an SMTP Host.
Yes to open the second SMTP screen opens.
Proceed to Step 6.
not want to configure an SMTP Host.
No to open the Application User Configuration
Proceed to Step 7.
In the second
Host Configuration screen:
hostname or IP address for the SMTP server.
OK to open the Application User Configuration screen.
Application User Configuration
screen. The application user for the Controller becomes
the System Application User and the default Super User.
Although it is possible to
enter unique Application User credentials on each installed node, you should
same Application User Name and password on all nodes.
The Application User credentials entered during the Controller installation are
the only ones recognized by Unified Intelligence Center.
confirm the application user password.
OK to open the Platform Configuration Confirmation screen. This
screen states that the platform configuration is complete.
Platform Configuration Confirmation screen, select