Center > Device Control to open the Control
Center page, where you can check the status of each device, and start, stop, or
restart devices. The status is displayed within five seconds of loading the
The rows on this page
contain five columns, with a radio button to the left of each row.
This page always
contains at least one row for the Controller.
As soon as you add a
device on the
Configuration page (see
Configuration), this Control Center page also shows a row for that Cisco
Unified Intelligence Center Reporting Server device. Use the
Filter feature to narrow the list of names (see
Table 1 Rows on This
The name of the
Controller, this field is populated by default.
For each member,
this field shows the name of the device from the Device Management page. Each
name is a link; click the name to open the sign in page for that node.
name on this page also changes it on the Device Configuration page.
The IP address
for the device.
A description of
the device (Controller or Member).
The server type
is always Unified Intelligence Center.
state of the device. Possible values are:
the server is in the process of starting up.
the server or subsystem that communicates with the Administration Console could
not be reached.
the server is not running.
service) - the server is running and active.
(partial service) - the server is running, but is not ready to work. The server
may be starting up.
the server is in the process of stopping.
Actions from this page
You can access and sign
in to a member node.
You can start, shutdown,
or restart a device by selecting the radio box for the device and clicking the
appropriate button. Buttons are dimmed for operations not supported on the
device at that time.
The status of the
operation is displayed at the bottom of the page. When starting, stopping, or
restarting, a confirmation dialog is displayed to confirm the current action
you are performing.
Start, Shutdown, and
Restart refer to the application process running on the server, and not the
hardware or operating system.
Shut down the
Cancel to the confirmation message.
Sign in to
the Reporting application on a member node
name of the member node to open a sign in page where you can enter your user
name and password.
refresh the status at any time. For example, if the status is unknown, you can
change the Refresh for status polling by using the drop down menu on the
upper-right of the page and click
options are: No refresh | Once | Every 30 seconds | Every 1 minutes | Every 5
minutes | Every 10 minutes.