Explore Cisco
How to Buy

Have an account?

  •   Personalized content
  •   Your products and support

Need an account?

Create an account

Cisco Unified CDR Analysis and Reporting Administration Guide, Release 11.0(1)

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents
Find Matches in This Book
Available Languages
Download Options

Book Title

Cisco Unified CDR Analysis and Reporting Administration Guide, Release 11.0(1)

Chapter Title

CAR Reports QoS Values

Results

Updated:
June 10, 2015

Chapter: CAR Reports QoS Values

CAR Reports QoS Values

Define QoS Values

QoS values get configured for lost packets, jitter, and latency based on good, acceptable, fair, or poor criteria.

If a call does not satisfy any of the criteria that are set for any of the four voice-quality categories, it receives a classification of NA (not applicable); likewise, if the system is not configured to generate CMR data (or if the CMR is bad), the CMR receives a classification of NA (not applicable).

Enter NA to ignore the values of a parameter. For example, a QoS parameter such as jitter, has NA, and the QoS is defined as good, which means that the QoS depends only on the values of latency and lost packets. All three parameters cannot have NA as values. Infinity designates the maximum value that is available for any parameter. If you specify a rule where a jitter value from 500 to Infinity is considered poor, a call with jitter greater than 500 receives a classification of poor.


Note

Be aware that the classifications of "NA" and "Infinity" are case-sensitive.

This section describes how to define the QoS values.

Procedure
    Step 1   Choose Report Config > Define QoS.

    The Define Quality of Service window displays. The following table describes the QoS default values.

    Table 1 QoS Default Values

    QoS Parameter

    Default

    Lost Packets

    Good - 0.00 to 15.00Acceptable - 15.01 to 30.00Fair - 30.01 to 45.00Poor - 45.01 to infinity

    Jitter

    Good - 0 to 20Acceptable - 21 to 100Fair - 101 to 150Poor - 151 to infinity

    Latency

    No default values apply.

    Step 2   To add rows, check the check box for the row above which you want to add a new row and click the Add Rows link.

    The new row gets added above the row that you checked, and the check box is cleared.

    The rows represent the values that CAR uses to quantify the conditions good, acceptable, fair, and poor in the QoS reports. For each value set, enter the upper and lower limits in the From and To columns.

    Note   

    To delete rows, check the check box for the row that you want to delete and click the Delete Rows link.

    Step 3   For each value that you have set, choose the Quality of Service.
    Step 4   Click the Update button.
    Tip   

    To restore the default QoS values, click the Restore Defaults button.

    Related Topics

    Additional Documentation

    • Administration Guide for Cisco Unified Communications Manager

    • Cisco Unified Serviceability Administration Guide

    • Cisco Unified Communications Manager Call Detail Records Administration Guide

    Was this Document Helpful?

    FeedbackFeedback

    Contact Cisco