Configure General Settings for Directory Connector
You can configure the name of the server running Cisco Directory Connector, the log levels, and the preferred settings for the domain controllers. The name of the connector appears on the dashboard in the connectors section, along with any other connectors that are running.
From Directory Connector, go to Configuration, and then click General.
In the Connector Name field, enter the connector name. This field shows only the computer name that is currently running the connector.
Choose the log level from the drop-down. By default, the log level is set to info. The available log levels are:
Choose the Preferred Domain Controllers to set the order of domain controllers for synchronizing identities.
The domain controllers are accessed from top to bottom. If the top controller is unavailable, choose the second controller on the list. If no controller is listed, you can access the primary controller.