Introduction

This document describes the new features, open caveats, and resolved caveats in Version 4.25 for the D9800 Network Transport Receiver.

New Features

The following is a list of new features for Version 4.25:

  • Zixi Push or Accept mode, which listens for incoming transport streams from the Zixi broadcaster.

  • Lock level password retry lockout.

Caveats

This section includes open and resolved caveats for this release.

Open Caveats

The following is a list of open caveats in Version 4.25. The caveat ID can be searched using the Cisco Bug Search Tool (https://tools.cisco.com/bugsearch), where you can find details about the caveat.

Bug ID

Description

CSCvf02757

RF noise fade causes video outputs from a D9800 single-stream unit to freeze, due to AV decode errors.

CSCvg26058

ABR2TS does not recover after Netropy packet loss and delay.

CSCvi96095

SDI picture is sometimes shifted by 4 pixels.

CSCva36677

Messages flicker when transitioning immediately between OSDs.

CSCva99839

D9800 subtitle top and bottom positions vary by a few lines.

CSCvb52656

Audio not available when tuning to a channel with audio and no PCR.

CSCvc11710

DTVCC loops are not parsed properly due to corrupted closed captions on SDI VANC.

CSCvc25703

Failure to signal Telecine mode in transcoded baseband streams.

CSCvc46096

Loss of input for transcoding - only supports Black Output.

CSCvc81714

No service cutoff when muting algorithm is enabled at default cutoff thresholds.

CSCvc81722

No audio restore on default transport DVBS and altered audio mute thresholds.

CSCvc89191

In D9800 single-stream units, IP input page is not updating WRT IP sources.

CSCvc89926

On D9800 multi-stream units, SDT is dropped in ASI and IP output when master program entry is set to the DPI service.

CSCvc95369

IP input delete failure message is incorrect.

CSCvd63395

Data loss reported with AMOL II.

CSCve64704

When IP link is down, traps and fault are not generated.

CSCve85199

Network ID Mismatch warning not cleared, even when NET ID matches.

CSCvf47839

SDI video shows intermittent black screen if primary video mode not set to Auto.

CSCvf81902

Delayed redundancy switching due to slow packet loss detection.

CSCvg30304

Alarm is not raised when force tune channel for unlicensed PE.

CSCvg40873

DPI PIDs are passed on to the TS Output when unauthorized and multiple PEs are tuned to same channel.

CSCvg59963

Issues when audio scrambled in HEVC channels.

CSCvg69310

If HTTP 404 error is returned during master manifest download, no more attempts are made.

CSCvh29909

Incorrect source IP address selected inconsistently.

CSCvh32005

IP Link Speed warning does not clear.

CSCvh66539

Freeze or outage occurs on HDMI port after specific channel and output changes.

CSCvh84667

Disaster Recovery: "No changes to apply" message appears while applying changes to the origin when disaster recovery switching is in progress.

CSCvh86441

Inband XCode control: MCT not fully processed when the table spans multiple sections.

CSCvh92507

Signal status alarm reset string is incorrect when input is disabled.

CSCvh96815

Audio and video continues to decode after changing CAMODE from Open to Std, where ECM and EMM are not present.

CSCvi16473

License rehost validation fails if the unit has duplicate uncounted licenses.

CSCvi23377

RF disaster recovery for single-stream unit: Backup program entries modified by user are updated in the Origin settings.

CSCvi60352

Audio artifacts with ABR2TS after input PCR loop or when VOD is enabled.

CSCvi82293

Program PIDs dropped while swapping channels with CAM card.

CSCvd86125

Fingerprint stays active after a channel is deleted.

CSCvj14984

Burn-in Fingerprint Trigger (FPT) appears corrupted in downstream units.

CSCvk37314

Unable to add Multicast IP address to the Static Multicast Filtering (FWD Filtered) list in D9800 GUI.

CSCvj48641

ABR input lock flips continuously after the input signal is removed and restored.

CSCvj17560

Ethernet redundancy alarm for link speed mismatch remains set when link is down.

CSCvj12739

Input Overflow alarm does not clear after disabling the input.

CSCvn71805

There is a longer than expected delay for audio to be heard when using AAC Passthrough.

CSCvn44036

DPI packets are not injected into Transport Outputs on units without NFE (D9800-SAT) card.

CSCvn70959

Disaster Recovery search path changes are not updated.

CSCvn61731

Audio 3&4 License alarm does not clear when input is deactivated or Audio source is set to "None".

CSCvn39411

Web UI Closed Caption changes not reflected on the front panel.

CSCvn56184

Cannot select high channel numbers in web UI.

CSCvn57632

MOIP input redundancy status does not reset after factory reset.

CSCvo72118

Multi-Stream and NDM - Banner not displayed in CVBS/HDMI and SDI outputs.

CSCvo75144

VANC and VBI writes are sometimes delayed.

CSCvo77824

Zixi input does not lock when DTLS certificate is not renewed or if there is a mismatch in the certificate details.

CSCvo86430

VideoGuard OSD message is not cleared if VideoGuard CAM is removed and re-inserted.

CSCvp01314

Web UI: IPI FEC status is not updated properly when changing from 2D to NONE.

Resolved Caveats

The following is a list of resolved caveats in Version 4.25. The caveat ID can be searched using the Cisco Bug Search Tool (https://tools.cisco.com/bugsearch), where you can find details about the caveat.

Bug ID

Description

CSCvo85226

DPM-Single-Stream Mode: Video PID drops when channel change in Service Channel only mode.

CSCvn73497

Multi-Stream Disaster Recovery: GOTO from RF to Origin (ASI/MOIP) not restored on output.

CSCvn69004

Transport Error - Continuity Count Error warning is triggered when tuning to 8PSK 5/6.

CSCvo80990

Total combined RF input rate is limited to 418 Mbps.

CSCvo02417

Unit reboots if it receives a table that has more sections than allowed.

CSCvo64934

Unit crashes when HEVC Extension Descriptor is present in the program.

CSCvn68914

Disaster Recovery with Backup and Restore - Unit reports it is locked to backup transport, but connected to origin.

CSCvo17610

CA Mode is not correctly applied for Zixi input type.

CSCvn80190

DPM Auto Sync user settings are not included in configuration (backup) setting file.

CSCvn78360

Green/Pink tint is noted in SDI output when switching PVO resolution from UHD2160pHDR to 1080p.

CSCvo72106

New IP entry is added in input setup page when switching from backup to origin.

CSCvo34728

Errors displaying DVB Subtitles with larger than normal glyph display duration.

CSCvg23082

HD Video is displayed as black on HDMI outputs.