This appendix provides the specifications and connector pin assignments for CDEs with the Serverworks chipset that shipped before December 1, 2006. This appendix includes the following sections:
This section contains the technical specifications for the CDEs with the Serverworks chipset.
|
3.50 (2U) ¥ 17.50 ¥ 28.50 in. (8.90 ¥ 44.45 ¥ 72.39 cm) |
|
Chassis fully configured (all slots filled): 53.5 lb. (24.27 kg) |
|
12 Serial-ATA 320, 400, or 500 GB hard drives |
|
1 Gigabit Ethernet interface |
|
1 Gigabit Ethernet interface |
|
3 Gigabit Ethernet interfaces |
|
High Definition MPEG-2 and Advanced Codec; Network PVR is fully supported |
|
8 Gigabytes RAM |
|
Two Dual Xeon @ 3.2 GHz (or above) |
|
IP, SNMP, FTP, Gigabit Ethernet, SSH, FSI, DSM-CC, LSCP, RTSP |
|
Marvell Serial-ATA |
|
Red Hat 7.3 distribution supporting Linux kernel 2.4.19 |
|
Two 60- GB small form-factor IDE hard drives |
|
Twisted Pair: Maximum of 330 ft (100 m) using Category 5E or higher, 4 pair Fiber-Optic SX multimode: 1640 ft (500 m) maximum (50/125 mm), |
|
Integrate with both the Tandberg and C-COR back office suite |
|
500 W (110 and 220 VAC or -48 VDC) redundant, hot-swappable1 |
|
Redundant with operation alarm monitored by system |
|
32 to 122°F (0 to 50°C) |
|
5 to 95% noncondensing |
|
5 to 98% (96 hours) |
|
-197 to 13120 ft (-60 to 4000 m) |
1 The power supplies for the CDE200 ISV server has not been investigated for hot-swapping. |
|
3.50 (2U) ¥ 17.50 ¥ 27.48 in. (8.90 ¥ 44.45 ¥ 69.80 cm) |
|
Chassis fully configured (all slots filled): 50 lb. (22.68 kg) |
|
4 SCSI 300-GB hard drives |
|
1 Gigabit Ethernet interface |
|
1 Gigabit Ethernet interface |
|
3 Gigabit Ethernet interfaces |
|
High Definition MPEG-2 and Advanced Codec |
|
8 Gigabytes RAM |
|
Two Dual Xeon @ 3.6 GHz (or above) |
|
IP, SNMP, FTP, Gigabit Ethernet, SSH, FSI, DSM-CC, LSCP, RTSP |
|
Ultra320 SCSI |
|
Red Hat 7.3 distribution supporting Linux kernel 2.4.19 |
|
2 SCSI 73-GB hard drives |
|
Twisted Pair: Maximum of 330 ft (100 m) using Category 5E or higher, 4 pair Fiber-Optic SX multimode: 1640 ft (500 m) maximum (50/125 mm), |
|
Integrate with both the Tandberg and C-COR back office suite |
|
625 W (110 and 220 VAC or -48 VDC) redundant, hot-swappable1 |
|
Redundant with operation alarm monitored by system |
|
50 to 95°F (10 to 35°C) for altitudes from 0 to 3000 ft (914.4 m) decrease system temperature by 33.35°F for every 1000 feet increase in altitude |
|
8 to 80% noncondensing |
1 The power supplies for the CDE200 ISV server has not been investigated for hot-swapping. |
Figure C-1 shows the location of all connectors for a CDE100.
Figure C-1 CDE100 Connector Locations
|
Power connectors |
|
Serial console interface |
|
Mouse connector |
|
VGA interface |
|
Keyboard connector |
|
Management interface (eth0) |
Figure C-2 shows the location of all connectors for a CDE200.
Figure C-2 CDE200 Connector Locations
|
Power connectors |
|
Serial console interface |
|
Mouse connector |
|
Management Interface (eth1) |
|
Keyboard connector |
|
Stream interfaces (eth3, eth4, eth5) |
|
VGA interface |
|
Ingest Interface (eth2) |
Figure C-3 shows the location of all connectors for a CDE200 (IBM).
Figure C-3 CDE200 (IBM) Connector Locations
|
Serial console interface |
|
Ingest Interface (eth2) |
|
Mouse connector |
|
Management Interface (eth0) |
|
Keyboard connector |
|
Stream interfaces (eth3, eth4, eth5) |
|
VGA interface |
|
Power connector |
Figure C-4 shows the location of all the connectors for a CDE300.
Figure C-4 CDE300 Connector Locations
.
|
Power connectors |
|
VGA interface |
|
Mouse connector |
|
Management interface (eth0) |
|
Keyboard connector |
|
Cache/Stream interfaces (eth2 through eth13) |
|
Serial console interface |
Figure C-5 shows the location of all the connectors for a CDE400 with four cache interfaces.
Figure C-5 CDE400 with Four Cache Interfaces Connector Locations
Figure C-6 shows the location of all the connectors for a CDE400 with six cache interfaces.
Figure C-6 CDE400 with Six Cache Interfaces Connector Locations