Create UCS Service
Profile
|
This
task allows to create a new UCS Service Profile.
|
Add vNic to UCS Service
Profile
|
This
task allows you to add vNIC to the UCS Service Profile.
|
Add iSCSI vNIC to UCS Service
Profile
|
This
task allows you to add iSCSI vNIC to the UCS Service Profile.
|
IBM Storwize iSCSI Boot
Target
|
This
task allows you to configure iSCSI boot targets.
|
Create Service Profile iSCSI
Boot Policy
|
This task allows you to configure the iSCSI Boot Policy for the existing UCSM
Service Profile. You can set the iSCSI Boot Parameters and create iSCSI Static
Targets.
|
Associate UCS Server
Profile
|
This
task allows you to select the UCS Service Profile and associate it with the
selected UCS Server.
|
Create IBM Storwize
Volume
|
This
task allows you to create a new volume on the host. The volumes are built from
extents in the storage pools, and hence the size can be increased or decreased.
You can Create volumes of type Generic, Thin-Provision, Mirrored and Compressed
volumes.
|
Create IBM Storwize Host
(iSCSI)
|
This
task allows you to create a host entry by using a WWPN/WWNN number of the
remote server and associate one or more HBA WWPNs or iSCSI names with a logical
host object.
|
Map IBM Storwize Volume To
Host
|
This
task allows you to create a new mapping between the volume and the host, which
makes the volume to be accessible for input/output operations to the specified
host.
|
Set up PXE Boot
|
This
task allows you to specify PXE Boot parameters required like OS type for the
Host, Host Name, Server IP Address Range, MAC Address, NetMask, Gateway, Name
Server, Password and Time Zone.
|
Power On UCS
Server
|
This
task lets you to power on the UCS Server and this task uses the UCS Service
Profile to turn the power on for the UCS Server. (This task can be used only
when there is a UCS Service Profile associated with the UCS Server)
|
Monitor PXE Boot
|
This
task monitors the PXE Boot that specifies the maximum amount of time to wait
for PXE Boot.
|
Modify UCS Service Profile
Boot Policy
|
This
task allows you to specify the new boot policy for the selected UCS Service
Profile (modify the UCS Service Profile with the new boot policy that allows to
modify the boot order for the UCS Service Profile.)
|
Wait for Specified
Duration
|
This
is a generic task that you can use it in the workflow to wait for a specified
duration.
|
Restet UCS
Server
|
This
task allows you to perform a hard reset on the UCS Server irrespective of the
UCS Service Profile associated with the server.
|
Wait for Specified
Duration
|
This
is a generic task that you can use it in the workflow to wait for a specified
duration.
|
Register Host with
vCenter
|
This
task allows you to register a new host within the selected cloud (vCenter) and
also place the host exactly where you want to it be on the cluster/datacenter.
|