Cisco UCS S3260 Storage Server Chassis Installation and Service Guide
Bias-Free Language
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
- Updated:
- June 9, 2021
Chapter: Installation for Cisco UCS Manager Integration
Installation for Cisco UCS Manager Integration
Cisco UCS manager integration requires Cisco UCS Manager 3.1(2) or later. You can integrate a system that has either M3 or M4 server nodes, but the system must be using Cisco IMC 2.0(13) or later firmware.
Note
UCS S3260’s default mode is standalone. If you are integrating the Cisco UCS S3260 Server chassis with Cisco UCS Manager, refer to Resetting Cisco IMC to Factory Defaults to reset the server to factory defaults.
The Cisco UCS integration instructions are in the GUI and CLI integration guides found here:
Cisco UCS S3260 Server Integration with UCS Manager Guides
Refer to the guide that is for the version of Cisco UCS Manager that you are using.
Feedback