Using Cisco TelePresence Recording Server CLI Commands
•Starting a CLI Session
•CLI Command Basics
•Ending a CLI Session
This chapter explains how to use the Cisco TelePresence Recording Server (CTRS) command line interface (CLI).
Starting a CLI Session
You can access the CTRS CLI through the physical console or remotely. If you want to access the CTRS CLI remotely, use Secure Shell (SSH) from a personal computer or workstation to connect securely to CTRS.
You will need the following to log in to CTRS:
•CTRS IP address
•Admin ID and password
Note The admin ID and password can be changed from the default in the Cisco Unified Communications Manager (Unified CM) for CTRS device page.
To start a CLI session:
Step 1 From a remote system, use SSH to connect securely to CTRS. In the SSH client, enter the following information: ssh adminname@IP Address
•adminname is the Admin ID
•IP Address is the IP address of CTRS
Step 2 When the system prompts you, enter the password.
Step 3 The CLI prompt displays. You can now enter any command.
Note The prompt will always be "admin."
CLI Command Basics
•Enter the beginning of a command and press Tab to have the system complete the command for you.
•Enter a full command and press Tab to display all commands or subcommands that are available. If you press Tab and the current command line repeats, no additional syntax is available.
•To get detailed help, enter help command name at the prompt.
•To get command syntax for a particular command, enter command name? at the prompt.
Ending a CLI Session
To end a CLI session:
Step 1 At the prompt, enter quit.