This chapter lists the steps required to install the FastHub 108T/104T. The procedure described here assumes you are familiar with installing and using Ethernet repeaters, and that you are aware of the configuration and planning requirements for a 100 Base-T network.
Check the FastHub 108T/104T package. It should contain the following items:
•The FastHub 108T or 104T unit
•This FastHub 108T and 104T User Guide
•Warranty package
•Cushioning kit: four rubber feet with instructions
•Power cord
Note If any of these items are missing, notify Cisco Systems.
Please note that this is an abbreviated installation procedure. For a more detailed description of the installation procedures, refer to the "" chapter.
To install your FastHub 108T or 104T:
Step 1 Unpack the FastHub 108T or 104T unit.
Step 2 Place the FastHub 108T or 104T on a table or shelf.
Step 3 Attach the power cord to the FastHub 108T or 104T unit. Plug it into a power outlet.
Step 4 Cable the workstations, servers, or other 100Base-TX devices to the FastHub 108T or 104T.