t_day0_config_adv

Available Languages

Updated:March 30, 2018

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Quick Setup: Viewing Summary Page
You are reading: Quick Setup Tasks on Your Device > Quick Setup: Verifying Configuration Settings

Quick Setup: Viewing Summary Page

Verify your configuration and click Submit to save your changes. To go back and update configuration details, click the link to the previous configuration page.

Note: The Basic and Interface Configuration details apply to the wired device (switch) whereas the wireless configuration is applicable for the ME device.

When you click Submit, the device is configured and exits the Configuration Setup page. The PC displays a message and then attempts to connect to the device with the new device IP address. If you configured the device with an IP address that is in a different subnet from the PC, connectivity between the PC and the device is lost.

 

 

© 2018 Cisco Systems, Inc. All rights reserved.

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products