Chapter 1. In-Service Software Upgrade (ISSU)

- Information about In-Service Software Upgrade (ISSU)

- Supported and unsupported ISSU upgrade scenarios across releases

- Supported platforms for ISSU

- Release support matrix

- Limitations and restrictions for ISSU

- ISSU configuration

- Additional references for ISSU

Information about In-Service Software Upgrade (ISSU)

ISSU is a process that upgrades an image to another image on a device while the network continues to forward packets. ISSU helps network administrators avoid a network outage when performing a software upgrade. ISSU is supported in install mode.

ISSU is supported in dual SUP HA and StackWise Virtual system. In-Service Software Upgrade is performed either in a single step or in three-steps.

Supported and unsupported ISSU upgrade scenarios across releases

To clearly outline the supported and unsupported In-Service Software Upgrade (ISSU) scenarios between different Cisco IOS XE release trains, including key guidelines, operational caveats, and recommendations to ensure reliable and compliant upgrade planning.

Supported Scenarios

Unsupported Scenarios

- Within a major release train (17.x or 26.x), ISSU is supported between any two Extended Maintenance (EM) releases that are released not more than 3 years apart.

- Within a major release train, ISSU is supported from:

- Any EM (EM1, EM2, EM3) release to another EM (EM1, EM2, EM3) release

Example:

26.1.x to 26.1.x, 26.2.x and so on

27.1.x to 27.1.x, 27.2.x and so on

- Any release within the same EM release

Example:

17.18.x to 17.18.x,

26.1.x to 26.1.x,

27.1.x to 27.1.x,

26.2.x to 26.2.x,

27.2.x to 27.2.x

- ISSU Recommendation:

- From any EM recommended release on CCO to current EM Recommended release on CCO

Note

FPGA upgrade has been decoupled from ISSU to facilitate ISSU within the major release train for 3 years. You can upgrade FPGA through CLI during maintenance windows that require full reload.

- ISSU is not supported on engineering special releases and .s (or similar) images.

- ISSU is not supported between Licensed Data Payload Encryption (LDPE) and No Payload Encryption (NPE) Cisco IOS XE software image.

- ISSU downgrades are not supported.

Note

No configuration changes should be performed while ISSU is being performed.

Supported platforms for ISSU

To enable users to quickly identify the supported hardware platforms and their corresponding initial software releases for In-Service Software Upgrade (ISSU), ensuring correct deployment and upgrade planning.

Platforms

ISSU Starting Release

C9610 (Dual supervisor)/ HA

17.18.2

C9610R Stackwise Virtual (SVL)

17.18.3a

Release support matrix

To provide detailed reference tables showing which Cisco IOS XE releases support ISSU for each Cisco C9610 deployment scenario, enabling users to determine upgrade compatibility for their devices.

For Cisco C9610 in dual supervisor/HA module configuration, ISSU support starts from Cisco IOS XE 17.18.2.

Cisco C9610 with Dual Supervisor/HA Module Configuration

From/To

17.18.1

17.18.2

17.18.3a

17.18.1

—

x

x

17.18.2

x

—

✓

17.18.3a

x

x

—

Cisco C9610 with Stackwise Virtual

From/To

17.18.2

17.18.3a

17.18.2

—

x

17.18.3a

x

—

Limitations and restrictions for ISSU

- ISSU upgrade between Cisco IOS XE releases 17.18.1 to 17.18.2 and 17.18.3a failed with an incompatible image error for Cisco C9610 Series Smart Switches with Dual Supervisor/HA setup. See CSCwr63904 for more details.

- ISSU upgrade between Cisco IOS XE releases 17.18.2 to 17.18.3a is not supported on Cisco C9610R Series Smart Switches with Stackwise Virtual setup. See CSCwt13742 for more details.

- Quad Supervisor module configuration with StackWise Virtual topology is not supported on Cisco C9610 Series Smart Switches Supervisor 3 Module (C9610R SUP-3 and SUP-3-XL).

ISSU configuration

To configure ISSU, see In-Service Software Upgrade (ISSU).

Additional references for ISSU

To provide direct access to related documents that supports In-Service Software Upgrade (ISSU) on Cisco C9610 Series Smart Switches, including configuration guides and release notes needed for planning, implementation, and troubleshooting.

Related Topic

Document Title

Software Configuration Guides

High Availability Configuration Guide

Release Notes

Release Notes for Cisco C9610 Series Smart Switches

Full Cisco Trademarks with Software License

THE SPECIFICATIONS AND INFORMATION REGARDING THE PRODUCTS IN THIS MANUAL ARE SUBJECT TO CHANGE WITHOUT NOTICE. ALL STATEMENTS, INFORMATION, AND RECOMMENDATIONS IN THIS MANUAL ARE BELIEVED TO BE ACCURATE BUT ARE PRESENTED WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED. USERS MUST TAKE FULL RESPONSIBILITY FOR THEIR APPLICATION OF ANY PRODUCTS.

THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH IN THE INFORMATION PACKET THAT SHIPPED WITH THE PRODUCT AND ARE INCORPORATED HEREIN BY THIS REFERENCE. IF YOU ARE UNABLE TO LOCATE THE SOFTWARE LICENSE OR LIMITED WARRANTY, CONTACT YOUR CISCO REPRESENTATIVE FOR A COPY.

The Cisco implementation of TCP header compression is an adaptation of a program developed by the University of California, Berkeley (UCB) as part of UCB's public domain version of the UNIX operating system. All rights reserved. Copyright © 1981, Regents of the University of California.

NOTWITHSTANDING ANY OTHER WARRANTY HEREIN, ALL DOCUMENT FILES AND SOFTWARE OF THESE SUPPLIERS ARE PROVIDED “AS IS" WITH ALL FAULTS. CISCO AND THE ABOVE-NAMED SUPPLIERS DISCLAIM ALL WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, WITHOUT LIMITATION, THOSE OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT OR ARISING FROM A COURSE OF DEALING, USAGE, OR TRADE PRACTICE.

IN NO EVENT SHALL CISCO OR ITS SUPPLIERS BE LIABLE FOR ANY INDIRECT, SPECIAL, CONSEQUENTIAL, OR INCIDENTAL DAMAGES, INCLUDING, WITHOUT LIMITATION, LOST PROFITS OR LOSS OR DAMAGE TO DATA ARISING OUT OF THE USE OR INABILITY TO USE THIS MANUAL, EVEN IF CISCO OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be actual addresses and phone numbers. Any examples, command display output, network topology diagrams, and other figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses or phone numbers in illustrative content is unintentional and coincidental.

All printed copies and duplicate soft copies of this document are considered uncontrolled. See the current online version for the latest version.

Cisco has more than 200 offices worldwide. Addresses and phone numbers are listed on the Cisco website at www.cisco.com/go/offices.

Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: https://www.cisco.com/c/en/us/about/legal/trademarks.html. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1721R)