Configuring 2-event Classification

Finding Feature Information

Your software release may not support all the features documented in this module. For the latest caveats and feature information, see Bug Search Tool and the release notes for your platform and software release. To find information about the features documented in this module, and to see a list of the releases in which each feature is supported, see the feature information table at the end of this module.

Use Cisco Feature Navigator to find information about platform support and Cisco software image support. To access Cisco Feature Navigator, go to http:/​/​www.cisco.com/​go/​cfn. An account on Cisco.com is not required.

Information about 2-event Classification

When a class 4 device gets detected, IOS allocates 30W without any CDP or LLDP negotiation. This means that even before the link comes up the class 4 power device gets 30W.

Also, on the hardware level the PSE does a 2-event classification which allows a class 4 PD to detect PSE capability of providing 30W from hardware, register itself and it can move up to PoE+ level without waiting for any CDP/LLDP packet exchange.

Once 2-event is enabled on a port, you need to manually shut/un-shut the port or connect the PD again to start the IEEE detection again. Power budget allocation for a class-4 device will be 30W if 2-event classification is enabled on the port, else it will be 15.4W.

Configuring 2-event Classification

To configure the switch for a 2-event Classification, perform the steps given below:

SUMMARY STEPS

    1.    enable

    2.    configure terminal

    3.    interface interface-id

    4.    power inline port 2-event

    5.    end


DETAILED STEPS
     Command or ActionPurpose
    Step 1 enable


    Example: 
    SwitchDevice> enable
     

    Enables privileged EXEC mode. Enter your password if prompted.

     

    Step 2configure terminal


    Example: 
    SwitchDevice# configure terminal
     

    Enters global configuration mode.

     
    Step 3interface interface-id


    Example: 
    SwitchDevice(config)# interface gigabitethernet2/0/1
     

    Specifies the physical port to be configured, and enters interface configuration mode.

     
    Step 4 power inline port 2-event


    Example: 
    SwitchDevice(config-if)# power inline port 2-event
     

    Configures 2-event classification on the switch.

     
    Step 5end


    Example: 
    SwitchDevice(config-if)# end
     

    Returns to privileged EXEC mode.

     
    Related References
    Example: Configuring 2-Event Classification

    Example: Configuring 2-Event Classification

    This example shows how you can configure 2-event classification. 

    SwitchDevice> enable
SwitchDevice# configure terminal
SwitchDevice(config)#  interface gigabitethernet2/0/1 
SwitchDevice(config-if)# power inline port 2-event
SwitchDevice(config-if)# end
    Related Tasks
    Configuring 2-event Classification