||Generates STP bridge MIB traps.
||Generates a trap when the cluster configuration changes.
||Generates a trap for SNMP configuration changes.
||Generates a trap for SNMP copy configuration changes.
||Allow CPU-related traps.
||Generates a trap for SNMP entity changes.
||Generates environmental monitor traps. You can enable any or all of these environmental traps: fan, shutdown, status, supply,
||Generates SNMP FLASH notifications. In a switch stack, you can optionally enable notification for flash insertion or removal, which would cause a trap to be issued whenever
a switch in the stack is removed or inserted (physical removal, power cycle, or reload).
||Generates entity field-replaceable unit (FRU) control traps. In the switch stack, this trap refers to the insertion or removal of a switch in the stack.
||Generates a trap for Hot Standby Router Protocol (HSRP) changes.
||Generates a trap for IP multicast routing changes.
||Generates a trap for MAC address notifications.
||Generates a trap for Open Shortest Path First (OSPF) changes. You can enable any or all of these traps: Cisco specific, errors,
link-state advertisement, rate limit, retransmit, and state changes.
||Generates a trap for Protocol-Independent Multicast (PIM) changes. You can enable any or all of these traps: invalid PIM messages,
neighbor changes, and rendezvous point (RP)-mapping changes.
Generates SNMP port security traps. You can also set a maximum trap rate per second. The range is from 0 to 1000; the default
is 0, which means that there is no rate limit.
When you configure a trap by using the notification type port-security , configure the port security trap first, and then configure the port security trap rate:
snmp-server enable traps port-security
snmp-server enable traps port-security trap-rate rate
||Generates a trap for SNMP-type notifications for authentication, cold start, warm start, link up or link down.
||Generates a trap for SNMP storm-control. You can also set a maximum trap rate per minute. The range is from 0 to 1000; the
default is 0 (no limit is imposed; a trap is sent at every occurrence).
||Generates SNMP STP Extended MIB traps.
||Generates SNMP syslog traps.
||Generates a trap for TCP connections. This trap is enabled by default.
||Generates a trap for SNMP VLAN membership changes.
||Generates SNMP VLAN created traps.
||Generates SNMP VLAN deleted traps.
||Generates a trap for VLAN Trunking Protocol (VTP) changes.