Supported MIBs
This appendix lists the supported management information base (MIBs) for this release on the Catalyst 3560 switch. It contains these sections:
•MIB List
•Using FTP to Access the MIB Files
MIB List
•BRIDGE-MIB
Note The BRIDGE-MIB supports the context of a single VLAN. By default, SNMP messages using the configured community string always provide information for VLAN 1. To obtain the BRIDGE-MIB information for other VLANs, for example VLAN x, use this community string in the SNMP message: configured community string @x.
•CISCO-ADMISSION-POLICY-MIB
•CISCO-AUTH-FRAMEWORK-MIB
•CISCO-CABLE-DIAG-MIB
•CISCO-CDP-MIB
•CISCO-CLUSTER-MIB
•CISCO-CONFIG-COPY-MIB
•CISCO-CONFIG-MAN-MIB
•CISCO-ENTITY-FRU-CONTROL-MIB
•CISCO-ENTITY-VENDORTYPE-OID-MIB
•CISCO-ENVMON-MIB
•CISCO-ERR-DISABLE-MIB
•CISCO-FLASH-MIB (Flash memory on all switches is modeled as removable flash memory.)
•CISCO-FTP-CLIENT-MIB
•CISCO-HSRP-MIB
•CISCO-HSRP-EXT-MIB (partial support)
•CISCO-IETF-IP-MIB
•CISCO-IETF-IP-FORWARDING-MIB
•CISCO-IGMP-FILTER-MIB
•CISCO-IMAGE-MIB
•CISCO IP-STAT-MIB
•CISCO-L2L3-INTERFACE-CONFIG-MIB
•CISCO-LAG-MIB
•CISCO-MAC-AUTH-BYPASS
•CISCO-MAC-NOTIFICATION-MIB
•CISCO-MEMORY-POOL-MIB
•CISCO-NAC-NAD-MIB
•CISCO-PAE-MIB
•CISCO-PAGP-MIB
•CISCO-PING-MIB
•CISCO-PORT-QOS-MIB (only the packet counters are supported; the octet counters are not supported)
•CISCO-POWER-ETHERNET-EXT-MIB
•CISCO-PRODUCTS-MIB
•CISCO-PROCESS-MIB
•CISCO-RTTMON-MIB
•CISCO-SMI-MIB
•CISCO-STP-EXTENSIONS-MIB
•CISCO-SYSLOG-MIB
•CISCO-TC-MIB
•CISCO-TCP-MIB
•CISCO-UDLDP-MIB
•CISCO-VLAN-IFTABLE-RELATIONSHIP-MIB
•CISCO-VLAN-MEMBERSHIP-MIB
•CISCO-VTP-MIB
•CISCO-CONFIG-COPY-MIB
•ENTITY-MIB
•ETHERLIKE-MIB
•IEEE8021-PAE-MIB
•IEEE8023-LAG-MIB
•IF-MIB (In and out counters for VLANs are not supported.)
•IGMP-MIB
•INET-ADDRESS-MIB
•IPMROUTE-MIB
•LLDP MED MIB
•OLD-CISCO-CHASSIS-MIB
•OLD-CISCO-FLASH-MIB
•OLD-CISCO-INTERFACES-MIB
•OLD-CISCO-IP-MIB
•OLD-CISCO-SYS-MIB
•OLD-CISCO-TCP-MIB
•OLD-CISCO-TS-MIB
•PIM-MIB
•RFC1213-MIB (Functionality is as per the agent capabilities specified in the CISCO-RFC1213-CAPABILITY.my.)
•RFC1253-MIB (OSPF-MIB)
•RMON-MIB
•RMON2-MIB
•SNMP-FRAMEWORK-MIB
•SNMP-MPD-MIB
•SNMP-NOTIFICATION-MIB
•SNMP-TARGET-MIB
•SNMPv2-MIB
•TCP-MIB
•UDP-MIB
Note You can also use this URL for a list of supported MIBs for the Catalyst 3560 switch:
ftp://ftp.cisco.com/pub/mibs/supportlists/cat3560/cat3560-supportlist.htm
You can access other information about MIBs and Cisco products on the Cisco web site:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
Using FTP to Access the MIB Files
You can get each MIB file by using this procedure:
Step 1 Make sure that your FTP client is in passive mode.
Note Some FTP clients do not support passive mode.
Step 2 Use FTP to access the server ftp.cisco.com.
Step 3 Log in with the username anonymous.
Step 4 Enter your e-mail username when prompted for the password.
Step 5 At the ftp>
prompt, change directories to /pub/mibs/v1 and /pub/mibs/v2.
Step 6 Use the get MIB_filename command to obtain a copy of the MIB file.