Catalyst 2350 Switch Software Configuration Guide, Release 12.2(46)EY

Supported MIBs

---

This appendix lists the supported management information base (MIBs) for this release on the Catalyst 2350 switch. It contains these sections:

•MIB List

•Using FTP to Access the MIB Files

MIB List

•BRIDGE-MIB

---

Note The BRIDGE-MIB supports the context of a single VLAN. By default, SNMP messages using the configured community string always provide information for VLAN 1. To obtain the BRIDGE-MIB information for other VLANs, for example VLAN n, use this community string in the SNMP message: configured community string @n.

---

•CISCO-CDP-MIB

•CISCO-CLUSTER-MIB

•CISCO-CONFIG-MAN-MIB

•CISCO-ENTITY-FRU-CONTROL-MIB

•CISCO-ENVMON-MIB

•CISCO-FLASH-MIB (Flash memory on all switches is modeled as removable flash memory.)

•CISCO-FTP-CLIENT-MIB

•CISCO-IGMP-FILTER-MIB

•CISCO-IMAGE-MIB

•CISCO IP-STAT-MIB

•CISCO-L2L3-INTERFACE-CONFIG-MIB

•CISCO-MEMORY-POOL-MIB

•CISCO-PAGP-MIB

•CISCO-PING-MIB

•CISCO-PRODUCTS-MIB

•CISCO-RTTMON-MIB

•CISCO-STP-EXTENSIONS-MIB

•CISCO-SYSLOG-MIB

•CISCO-TCP-MIB

•CISCO-VLAN-IFTABLE-RELATIONSHIP-MIB

•CISCO-VLAN-MEMBERSHIP-MIB

•CISCO-VTP-MIB

•ENTITY-MIB

•ETHERLIKE-MIB

•IF-MIB (In and out counters for VLANs are not supported.)

•IGMP-MIB

•IPMROUTE-MIB

•OLD-CISCO-CHASSIS-MIB

•OLD-CISCO-FLASH-MIB

•OLD-CISCO-INTERFACES-MIB

•OLD-CISCO-IP-MIB

•OLD-CISCO-SYS-MIB

•OLD-CISCO-TCP-MIB

•OLD-CISCO-TS-MIB

•PIM-MIB

•RFC1213-MIB

•RMON-MIB

•RMON2-MIB

•SNMP-FRAMEWORK-MIB

•SNMP-MPD-MIB

•SNMP-NOTIFICATION-MIB

•SNMP-TARGET-MIB

•SNMPv2-MIB

•TCP-MIB

•UDP-MIB

---

Note You can access other information about MIBs and Cisco products on the Cisco web site:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml

---

Using FTP to Access the MIB Files

You can get each MIB file by using this procedure:

---

Step 1 Make sure that your FTP client is in passive mode.

---

Note Some FTP clients do not support passive mode.

---

Step 2 Use FTP to access the server ftp.cisco.com.

Step 3 Log in with the username anonymous.

Step 4 Enter your e-mail username when prompted for the password.

Step 5 At the ftp> prompt, change directories to /pub/mibs/v1 and /pub/mibs/v2.

Step 6 Use the get MIB_filename command to obtain a copy of the MIB file.

---