Cisco Nexus 9000 Series NX-OS Fundamentals Configuration Guide, Release 6.x

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: September 23, 2014

Chapter: New and Changed Information

New and Changed Information

New and Changed Information

This chapter provides release-specific information for each new and changed feature in the Cisco Nexus 9000 Series NX-OS Fundamentals Guide, Release 6.x.

New and Changed Information

New and Changed Information

This table summarizes the new and changed features for the *Cisco Nexus 9000 Series NX-OS Fundamentals Configuration Guide, Release 6.x* and tells you where they are documented.

Table 1 New and Changed Features for Cisco NX-OS Release 6.x
Feature	Description	Changed in Release	Where Documented
Policy-based routing	Introduced this feature.	6.1(2)I3(1)	Overview
FTP and HTTP	Added the ability to configure the source interface.	6.1(2)I2(2a)	Using the Device File Systems, Directories, and Files
Cisco NX-OS setup utility	Added support for Layer 2 switching.	6.1(2)I2(1)	Using the Cisco NX-OS Setup Utility
CLI	Added support for VLAN interfaces.	6.1(2)I2(1)	Understanding the Command-Line Interface
DCNM	Introduced this feature.	6.1(2)I2(1)	Overview
Ethernet switching	Introduced this feature.	6.1(2)I2(1)	Overview
First-Hop Redundancy Protocols	Added support for HSRP and VRRP.	6.1(2)I2(1)	Overview
Multicast routing	Added support for IGMP snooping.	6.1(2)I2(1)	Overview
POAP	Added support for vPCs.	6.1(2)I2(1)	Using PowerOn Auto Provisioning
Security	Added support for MAC ACLs, VLAN ACLs, and traffic storm control.	6.1(2)I2(1)	Overview
Spanning Tree Protocol	Introduced this feature.	6.1(2)I2(1)	Overview

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)