Cisco Nexus 7000 Series NX-OS OTV Command Reference

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: April 16, 2015

Chapter: New and Changed Information

New and Changed Information

This chapter provides release-specific information for each new and changed feature in the Cisco Nexus 7000 Series NX-OS Overlay Transport Virtualization Command Reference. The latest version of this document is available at the following Cisco website:
http://www.cisco.com/c/en/us/support/switches/nexus-7000-series-switches/products-command-reference-list.html

To check for additional information about this Cisco NX-OS Release, see the Cisco NX-OS Release Notes available at the following Cisco website:
http://www.cisco.com/c/en/us/support/switches/nexus-7000-series-switches/products-release-notes-list.html

Table 1 summarizes the new and changed features for the Cisco Nexus 7000 Series NX-OS Overlay Transport Virtualization Command Reference.

Table 1 New and Changed Features
Feature	Description	Changed in Release
otv depolarization disable	Added support for the F3 Series module.	6.2(8)
otv broadcast-group	This command was introduced	6.2(2)
otv flood mac	This command was introduced	6.2(2)
otv isis bfd	This command was introduced	6.2(2)
otv vlan mapping	This command was introduced	6.2(2)
show bfd neighbors	This command was introduced	6.2(2)
show otv vlan-mapping	This command was introduced	6.2(2)
show otv mroute vlan	This command was introduced	6.2(2)
show otv vlan	Changed the command output to show the time remaining for the VLANs to become active after the overlay interface is unshut.	6.2(2)
show otv-isis track-adjacency-nexthop track-adjacency-nexthop	These commands were introduced	6.2(2)
otv arp-nd timeout	Added the otv arp-nd timeout command	6.1(1)
otv use-adjacency-server unicast-only show otv vlan-mapping otv extend-vlan	Added support for unicast cores using an adjacency server Added the overlay and vpn keywords Added the add and remove keywords	5.2(1)

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)