You must ensure that ITD is enabled before you enter this command.
You can enter the
itd global configuration mode command to enable
You can use the service probe to periodically monitor the node
health. The ITD feature supports PING, TCP, and UDP probes. The connected
appliance must support PING, TCP, or UDP probes and should be configured to
respond to probes that are initiated by ITD.
ITD probes all cluster group nodes including the nodes that are
configured as hot standby.
Probes are not supported for a device group with IPv6 nodes.
Before modifying the service parameters or device-group
parameters, you must enter the
shutdown command. Once the required
parameters are modified, you should enter the
shutdown command on the service.
This command requires the Enhanced Layer 2 Package license.