Cisco Nexus 7000 Series FCoE Configuration Guide 7.x

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: October 8, 2024

New and Changed Information

This section provides release-specific information for each new and changed feature documented for the Cisco Nexus 7000 Series switches.

Table 1. New and Changed Features
Feature	Description	Changed in Release
F3 FCoE support for FEX with physical port vPC and vPC+	FCoE over physical port vPC and vPC+ is supported on F3 series modules.	7.3(0)D1(1)
FCoE over FEX support on F3 series modules	FCoE over FEX is supported with N2348UPQ FEX over F3 modules.	7.3(0)D1(1)
Configuring Dynamic FCoE Using FabricPath	Support for using a Cisco Nexus 7000/7700 device as a spine in an FCoE over FabricPath network	7.2(0)D1(1)
FCoE over FEX	Support for Fibre Channel over Ethernet (FCoE) over Fabric Extenders (FEX). This feature allows Fibre Channel traffic to be carried on a FEX port	7.2(0)D1(1)
F3 Series Module support	FCoE support on F3 Series modules	7.2(0)D1(1)

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)