This chapter describes the Cisco NX-OS TrustSec commands that begin with F.
To enable the Cisco TrustSec feature, use the feature cts command. To revert to the default, use the no form of this command.
|
|
To use this command, you must enable the Cisco TrustSec feature using the feature dot1x command.
This example shows how to enable the Cisco TrustSec feature:
This example shows how to disable the Cisco TrustSec feature:
|
|
---|---|
To enable the 802.1X feature, use the feature dot1x command. To revert to the default setting, use the no form of this command.
|
|
You must use the feature dot1x command before you enable the Cisco TrustSec feature on the switch by using the feature cts command.
This example shows how to enable 802.1X:
This example shows how to disable 802.1X:
|
|
---|---|