Cisco Nexus 5500 Series NX-OS System Management Command Reference

Book Contents

Find Matches in This Book

Available Languages

Download Options

F Commands

F Commands

This chapter describes the system management commands that begin with F.

To enable the PTP feature, use the feature ptp command. To unconfigure the PTP feature, use the no form of this command.

feature ptp

no feature ptp

There are no arguments or keywords for this command.

None

Global configuration mode


Release	Modification
5.2(1)N1(1)	This command was introduced.

This example shows how to enable PTP on the device:

switch# configure terminal

switch(config)# feature ptp


Command	Description
feature ptp	Enables or disables PTP on the device.
ptp source	Configures the source IP address for all PTP packets.
ptp domain	Configures the domain number to use for this clock.
ptp priority1	Configures the priority 1 value to use when advertising this clock.
ptp priority2	Configures the priority 1 value to use when advertising this clock.
show ptp brief	Displays the PTP status.
show ptp clock	Displays the properties of the local clock.