-
null
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS quality of service (QoS) commands that begin with I.
To configure the differentiated dervices code point (DSCP) value of the packets in the Encapsulated Remote Switched Port Analyzer (ERSPAN) traffic, use the ip dscp command. To revert to the default value, use the no form of this command.
ip dscp dscp_value
no ip dscp dscp_value
dscp_value |
DSCP value of the packets in the ERSPAN traffic. The range is from 0 to 63. |
0
ERSPAN session configuration mode
|
|
5.2(1)N1(1) |
This command was introduced. |
This command does not require a license.
This example shows how to configure the DSCP value of the packets in the ESRSPAN traffic:
switch# configure terminal
switch(config)# monitor session 1 type erspan-source
switch(config-erspan-src)# ip dscp 10
switch(config-erspan-src)#
To configure the IP time-to-live (TTL) value of the Encapsulated Remote Switched Port Analyzer (ERSPAN) traffic, use the ip ttl command. To revert to the default configuration, use the no form of this command.
ip ttl ttl_value
no ip ttl ttl_value
ttl_value |
IP TTL value of the ERSPAN traffic. The range is from 1 to 255. |
255
ERSPAN session configuration mode
|
|
5.2(1)N1(1) |
This command was introduced. |
This command does not require a license.
This example shows how to configure the IP TTL value of the ESRSPAN source:
switch# configure terminal
switch(config)# monitor session 1 type erspan-source
switch(config-erspan-src)# ip ttl 30
switch(config-erspan-src)#
This example shows how to remove the IP TTL value from the ESRSPAN source:
switch# configure terminal
switch(config)# monitor session 1 type erspan-source
switch(config-erspan-src)# no ip ttl 30
switch(config-erspan-src)#