The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS interface commands that begin with M.
To configure a switch virtual interface (SVI) that should be used for in-band management, use the management command. To remove the in-band management access to a VLAN interface IP address, use the no form of this command.
Interface configuration mode
Switch profile configuration mode
|
|
---|---|
This example shows how to configure a VLAN interface to allow in-band management access:
This example shows how to remove the in-band management access to a VLAN interface:
|
|
---|---|
Displays the running configuration information for an interface. |