You can configure
the source channels for a SPAN session. These ports can be port channels
SAN port channels,
VSANs and VLANs. The monitored direction can be ingress, egress, or both
and applies to all physical ports in the group.
The following
example shows how to configure a port channel SPAN source:
switch# configure terminal
switch(config)# monitor session 2
switch(config-monitor)# source interface port-channel 1 rx
switch(config-monitor)# source interface port-channel 3 tx
switch(config-monitor)# source interface port-channel 5 both
switch(config-monitor)#
This example shows how
to configure a SAN port channel SPAN source:
switch(config-monitor)#switch# configure terminal
switch(config)# monitor session 2
switch(config-monitor)# source interface san-port-channel 3 rx
switch(config-monitor)#
The following
example shows how to configure a VLAN SPAN source:
switch# configure terminal
switch(config)# monitor session 2
switch(config-monitor)# source vlan 1
switch(config-monitor)#
switch(config-monitor)#This example shows how to configure a
VSAN SPAN source:
switch(config-monitor)#switch# configure terminal
switch(config)# monitor session 2
switch(config-monitor)# source vsan 1
switch(config-monitor)#