Cisco Nexus 3232C and 3264Q NX-OS Release Notes, Release 7.0(3)IX1(2a)

 

Cisco NX-OS Release 7.0(3)IX1(2a) is a special release for the Cisco Nexus 3232C and 3264Q switches. This release supports the features in Cisco Nexus 9000 Series NX-OS Release 7.0(3)I1(2) with a few exceptions (see the “Unsupported Features” section).

This release is not supported for the Cisco Nexus 3000 or 9000 Series switches, the Cisco Nexus 3164Q switch, or the Cisco Nexus 31128PQ switch.

This document describes the features, caveats, and limitations for Cisco NX-OS Release 7.0(3)IX1(2a) software for use on the Cisco Nexus 3232C and 3264Q switches. Use this document in combination with documents listed in the “Related Documentation” section.

Table 1 shows the online change history for this document.

Table 1 Online History Change

 

 

Contents

Introduction.. 2

System Requirements. 2

New and Changed Information.. 3

Caveats. 4

Installation Notes. 4

Limitations. 4

Unsupported Features. 5

Related Documentation.. 6

Obtaining Documentation and Submitting a Service Request. 6

 

Introduction

Cisco NX-OS software is a data center-class operating system designed for performance, resiliency, scalability, manageability, and programmability at its foundation. The Cisco NX-OS software provides a robust and comprehensive feature set that meets the requirements of virtualization and automation in mission-critical data center environments. The modular design of the Cisco NX-OS operating system makes zero-impact operations a reality and enables exceptional operational flexibility.

The Cisco Nexus 3232C and 3264Q switches use an enhanced version of Cisco NX-OS software with a single binary image, which simplifies image management.

System Requirements

This section includes the following sections:

■        Supported Device Hardware

■        Supported Optics

Supported Device Hardware

Table 2 and Table 3 list the Cisco Nexus hardware that Cisco NX-OS Release 7.0(3)IX1(2a) supports. For additional information about the supported hardware, see the Cisco Nexus 3000 Series Hardware Installation Guide.

Table 2 Cisco Nexus 3232C Switch Hardware

Table 3 Cisco Nexus 3264Q Switch Hardware

Supported Optics

See Cisco 10-, 40-, and 100-Gigabit Ethernet Transceiver Module Compatibility Matrices for a list of supported optical components.

New and Changed Information

This section lists the following topics:

■        New Hardware Features in Cisco NX-OS Release 7.0(3)IX1(2a)

■        New Software Features in Cisco NX-OS Release 7.0(3)IX1(2a)

New Hardware Features in Cisco NX-OS Release 7.0(3)IX1(2a)

This release does not include new hardware features.

New Software Features in Cisco NX-OS Release 7.0(3)IX1(2a)

This release does not include new software features.

Caveats

This section contains lists of open and resolved caveats.

■        Resolved Caveats—Cisco NX-OS Release 6.1(2)I3(4)

■        Open Caveats—Cisco NX-OS Release 7.0(3)IX1(2a)

 

Resolved Caveats—Cisco NX-OS Release 7.0(3)IX1(2a)

Table 4 lists the Resolved Caveats in the Cisco NX-OS Release 7.0(3)IX1(2a). Click the bug ID to access the Bug Search tool and see additional information about the bug.

Table 4 Resolved Caveats in Cisco NX-OS Release 6.1(2)I3(4)

Open Caveats—Cisco NX-OS Release 7.0(3)IX1(2a)

Table 5 lists the open caveats in Cisco NX-OS Release 7.0(3)IX1(2a). Click the bug ID to access the Bug Search tool and see additional information about the bug.

Table 5 Open Caveats in Cisco NX-OS Release 7.0(3)IX1(2a)

Installation Notes

Only one software image is required to load the Cisco NX-OS operating system. For installation instructions, see the Cisco Nexus 9000 Series NX-OS Software Upgrade and Downgrade Guide.

Limitations

This section lists limitations related to Cisco NX-OS Release 7.0(3)IX1(2a):

■        Layer 3 routed traffic for missing Layer 2 adjacency information is not flooded back onto VLAN members of ingress units when the source MAC address of routed traffic is a non-VDC MAC address. This limitation is for hardware flood traffic and can occur when the SVI has a user-configured MAC address.

■        The neighbor-down fib-accelerate command is supported in a BGP-only environment.

■        When a routed access control list (ACL) is applied to multiple switched virtual interfaces (SVIs) in the egress direction, TCAM resources are not shared.

■        When a VLAN ACL is applied to multiple VLANs, TCAM resources are not shared.

■        The hardware does not support range checks (Layer 4 operators) in egress TCAM. Because of this, ACL/QoS policies with Layer 4 operations-based classification need to be expanded to multiple entries in the egress TCAM. Egress TCAM space planning should take this limitation into account.

■        If the same QoS policy and ACL is applied on multiple interfaces, the label will be shared only when the QoS policy is applied with the no-stats option.

■        When multiple port VLAN mappings are configured on an interface during a rollback operation, the rollback feature fails.

Unsupported Features

This section lists the features that are supported in Cisco Nexus 9000 Series NX-OS Release 7.0(3)I1(2) but not in Cisco NX-OS Release 7.0(3)IX1(2a):

■        Automatic negotiation support for 25G and 50G ports on the Cisco Nexus 3232C switch

■        Cisco Nexus 2000 Series Fabric Extenders (FEX)

■        Cisco NX-OS to ACI conversion (The Cisco Nexus 3232C and 3264Q switches operate only in Cisco NX-OS mode.)

■        Delayed Link Aggregation Control Protocol (LACP)

■        Designated router delay

■        DHCP snooping

■        Dynamic ARP inspection (DAI)

■        Intelligent Traffic Director (ITD)

■        IP source guard (IPSG)

■        Policy-based routing (PBR)

■        Port loopback tests

■        Precision Time Protocol (PTP)

■        Private VLANs (PVLANs)

■        Q-in-Q VLAN tunnels

■        Resilient hashing

■        Switchport blocking

■        Symmetric hashing

■        TAP aggregation

■        Virtual Machine (VM) Tracker

■        Virtual port channel (vPC) peering between Cisco Nexus 3232C or 3264Q switches and Cisco Nexus 9300 Series switches or between Cisco Nexus 3232C or 3264Q switches and Cisco Nexus 3100 Series switches

■        VXLAN

Other Unsupported Features

This section lists the features that are not supported in both Cisco Nexus 9000 Series NX-OS Release 7.0(3)I1(2) and Cisco NX-OS Release 7.0(3)IX1(2a):

■        DHCP subnet broadcast is not supported.

■        Due to a Poodle vulnerability, SSLv3 is no longer supported.

Related Documentation

The Cisco Nexus 3232C and 3264Q Switches, Cisco NX-OS Release 7.0(3)IX1(2a) – Read Me First is available at the following URL:

http://www.cisco.com/c/en/us/support/switches/nexus-3000-series-switches/products-release-notes-list.html

The Cisco Nexus 3232C and 3264Q NX-OS Verified Scalability Guide, Release 7.0(3)IX1(2a) is available at the following URL:

http://www.cisco.com/c/en/us/support/switches/nexus-3000-series-switches/products-installation-and-configuration-guides-list.html

The entire Cisco Nexus 9000 Series NX-OS documentation set is available at the following URL:

http://www.cisco.com/c/en/us/support/switches/nexus-9000-series-switches/tsd-products-support-series-home.html

The Cisco Nexus 3000 Series Hardware Installation Guide is available at the following URL:

http://www.cisco.com/c/en/us/support/switches/nexus-3000-series-switches/products-installation-guides-list.html

New Documentation

This release does not include new documentation.

Documentation Feedback

To provide technical feedback on this document, or to report an error or omission, please send your comments to nexus9k-docfeedback@cisco.com. We appreciate your feedback.

Obtaining Documentation and Submitting a Service Request

For information on obtaining documentation and gathering additional information, see the monthly What’s New in Cisco Product Documentation, which also lists all new and revised Cisco technical documentation, at:

http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html

Open a service request online at:

https://tools.cisco.com/ServiceRequestTool/create/launch.do

Subscribe to the What’s New in Cisco Product Documentation as a Really Simple Syndication (RSS) feed and set content to be delivered directly to your desktop using a reader application. The RSS feeds are a free service and Cisco currently supports RSS version 2.0.

This product includes cryptographic software written by Eric Young (eay@cryptsoft.com). This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit. (http://www.openssl.org/). This product includes software written by Tim Hudson (tjh@cryptsoft.com).

Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1110R)

Cisco Nexus 3232C and 3264Q NX-OS Release Notes, Release 7.0(3)IX1(2a)

© 2016 Cisco Systems, Inc. All rights reserved.