New and Changed Information
This table summarizes the new and changed features for the Cisco Nexus 3000 Series NX-OS Label Switching Configuration Guide, Release 7.x and tells you where they are documented.
|
Feature |
Description |
Changed in Release |
Where Documented |
|---|---|---|---|
| Segment Routing Application (SR-APP) | Added support for Segment Routing Application (SR-APP) to configure SR. | 7.0(3)I7(3) | Configuring Segment Routing Using Segment Routing Application |
| IS-IS Segment Routing | Added support for configuring Segment Routing with IS-IS protocol. | 7.0(3)I7(3) | Configuring Segment Routing with IS-IS Protocol |
| Cisco Nexus 3500 Series switches | Added support for Cisco Nexus 3500 Series switches | 7.0(3)I7(2) | Refer the Guidelines and Limitations section for each feature. |
|
Configuring Segment Routing and SR-EVPN |
Added support for segment routing and SR-EVPN on Cisco Nexus C31108PC-V, C31108TC-V and C3132Q-V switches. |
7.0(3)I7(1) |
|
|
Configuring EVPN Over Segment Routing or MPLS |
Added support for configuring EVPN over SR or MPLS |
7.0(3)I6(1) |
|
|
Configuring BGP EVPN and Label Allocation Mode |
Added support for configuring BGP EVPN |
7.0(3)I6(1) |
|
|
Configuring MPLS Segment Routing OAM |
Added support for configuring MPLS Segment Routing OAM |
7.0(3)I6(1) |
|
|
BGP Link State Distribution |
Added support for Link State distribution using BGP. |
7.0(3)I5(1) |
|
|
BGP Egress Peer Engineering |
Added support for egress peer engineering using BGP. |
7.0(3)I5(1) |
|
|
MPLS Label Imposition |
Added a new chapter for MPLs Label Imposition |
7.0(3)I5(1) |
|
|
Segment Routing |
Added support for Segment Routing. |
7.0(3)I4(1) |
|
|
Static MPLS |
Replaced the mpls ip static command with the mpls ip forwarding command to enable MPLS on an interface. |
7.0(3)I3(1) |
|
|
Static MPLS |
Introduced this feature. |
7.0(3)I2(1) |
Feedback