|
|
|
|
no switchport |
This command gets an error message on the breakout interface. |
7.0(3)I2(1) |
|
vPC |
The output for this feature has changed. |
7.0(3)I2(1) |
|
VLAN Interface Configuration |
SVIs are not removed from the layer 3 interface table after running no interface vlan. Remove the VLAN itself to remove the SVI. |
7.0(3)I2(1) |
|
Interface Configuration |
Unknown unicast blocked, Unknown multicast blocked, and Mac learning outputs have been removed. |
7.0(3)I2(1) |
|
LACP Rate |
The lacp rate fast command is now only allowed with member interfaces in an admin DOWN state. |
7.0(3)I2(1) |
|
VXLAN Ingress Replication |
This command is enhanced to display all the VXLAN network identifiers (VNIs) configured for a particular peer. |
6.0(2)U5(1) |
|
MAC-Embedded IPv6 Address |
Introduced this feature |
6.0(2)U4(1) |
|
DHCP Client for Switch Provisioning |
Added the IPv6 option. |
6.0(2)U4(1) |
|
Layer 3 Interface |
Introduced a command to change the sampling interval for statistics collections on interfaces and an option to display input and output rates for all interfaces. |
6.0(2)U4(1) |
|
VXLAN |
Introduced this feature. |
6.0(2)U3(2) |
|
DHCP Client for Switch Provisioning |
Introduced this feature. |
6.0(2)U3(1) |
|
Downlink Delay |
Introduced this feature. |
6.0(2)U3(1) |
|
Symmetric Hashing |
Updated the command to include symmetric hashing. |
6.0(2)U2(3) |
|
Dynamic port breakout for Cisco Nexus 3172 |
Added support for Cisco Nexus 3172 and introduced a new command option. |
6.0(2)U2(3) |
|
Dynamic port breakout for Cisco Nexus 3132 |
Updated the speed command to configure 40 Gbps interface speed. Added a command to switch between QSFP ports and SFP+ ports. |
6.0(2)U2(1) |
|
Consistency Checkers |
The following consistency checkers were introduced to check for consistency and display the results:
- Port Channel Membership Consistency Checker
- Layer 3 Interface Consistency Checker
- Link State Consistency Checker
|
6.0(2)U2(1) |
|
Default interface configuration |
Added the command to revert an interface to its default configuration. |
6.0(2)U2(1) |
|
IP-in-IP Tunnel Support |
Updated the tunnel mode command to to select the IP-in-IP tunnel mode. |
6.0(2)U2(1) |
|
Layer 3 Interface MAC Address Configuration |
Command to change the default MAC address on Layer 3 interfaces. |
6.0(2)U2(1) |
|
Error-disabled Recovery |
Command to disable error-disabled recovery added |
6.0(2)U1(2) |
|
Switchport Trunks |
Default behavior of switchport trunkallowed vlans command changed. |
6.0(2)U1(1) |
|